I'm just learning about Forscan and a lot of the lingo. I made the change using Forscan and Livinitups spreadsheet to enable camera in motion but I too only see the rear camera. Can you explain what you checked and why? Thank you.
Only the rear camera(s) can be viewed while in motion.
Not entirely true. If your truck is equipped with rock crawling mode (in the driving mode selector) you can also get front cameras.
Best to post about that in the Forscan thread where the experts in that area lurk.
Mine went through. A weird and initially unsettling configuration error at the tail end of the programming cycle threw a bunch of communication DTCs but it turned out to be nothing. No U2100/initial configuration codes requiring a PMI, update cleared the FDRS queue, five DIDs changed and one press of clear and retest wiped all the DTCs. Everything works and no new codes for two days so far. I wouldn’t recommend it for the faint of heart, however, unless you’re trying to fix something and need to do it.
Repost your question in the Vin request lookup thread, you'll get a answer there. ?
I’ll be rooting for you but don’t expect you to get very far. Borrowing a cable and spending $50 and a few hours seems like much less of a hassle and you won’t void your warranty.
Best of luck to you, but unless your billable rate is like 2¢/hr, it will be faster, cheaper, and easier to just DIY.
I am a retired attorney and find your solicitation on this forum unseemly. On my own behalf only, this is to advise you that I am reserving all rights under Rule 23 to oppose certification and affirmatively opt out of any certified class.
