50/50 view cam at speed help

[Ffdlt371]

Hey everyone. I have looked everywhere and I can't seem to find the info on forscan changes needed to enable the 50/50 split camera view at speed.

Please point me in the right direction. My eye are killing me!

Thank you!!

Sponsored

 

[antho]

Depending on your exising values at the asterisk.

 

[Ffdlt371]

I'll try. Thank you!!

 

[Ffdlt371]

Success!

Thanks again

 

[TheGoatman]

What is this?

 

[Ffdlt371]

This enables the 50/50 cameras at speed.
The view is the left and right side mirror cameras. I'll post a pic.

 

[HammaMan]

What is this?

This view while driving

 

[Ffdlt371]

Yes

 

[Txmade]

Don’t you have to have a trailer attached?

 

[Ffdlt371]

No, not for the 50/50.
You do need a trailer attached for the side camera view with turn signal. Then it just shows the left or right camera when you signal.

 

[antho]

Don’t you have to have a trailer attached?

@Txmade No. You are thinking of Turn signal views. The 50/50 image posted above isn’t exactly the same. That’s more for backing a trailer. See below for the actual 50/50. Same concept but works in forward/drive.

 

[Bucknut22]

I didn't know this was a thing, so i'm so glad y'all posted this! My wife's honda has it and she always complains the truck doesn't!

 

[hanzie411]

Depending on your exising values at the asterisk.

I would like this. What do you mean depending on your existing values at asterisk? What values should it be to enable this?

 

[Ffdlt371]

I would like this. What do you mean depending on your existing values at asterisk? What values should it be to enable this?

When you go into forscan to make your changes, look at the forscan spreadsheet for what the values mean. Most lines of code in your as-built cover multiple things.

For example, one of the values you will change can be a,b,c,d,e,1,2,3,4, or 5. A lot of different values and the correct one for you will depend on your trucks configuration. All you have to do is pick the value that only changes what you are trying to change. Lol at what your existing value is at that location and change it to the new value that is almost the same but turns on the feature you are looking to enable.

 

[antho]

@hanzie411
For instance, I dont know what you currently have as the value. So i can't tell you what needs to be there. you have to know your existing value and look at the sheet to find what you need. You need to enable the front and rear rock crawl feature in the tabe below.
If you currently have a 0 change it to a 3
If you currently have a 4 change it to a 7

Sponsored