The reason for a much higher cost of the Raptor is that it has a unique die set for its parts. The cab is 12 inches wider than a standard F-150. Parts like fenders, hood, cowl, facia, modified cab floor, cab back panel, and the entire box.
No. Not even close. The Raptor is 80” wide, same as the standard F150. Raptor does have wider fenders and suspension but overall, the cabs are the same.
Apparently you’ve never looked up the dimensions! F-150 84 inches wide, Raptor is 96 inches wide. Looked it up when I couldn’t get it in my garage. Most of the sheet metal is unique to the Raptor!
Actually did did just to verify I was correct before I posted. Additionally, I’ve looked at the two hoods side by side. The Raptor cab is NOT 12” wider. You are wrong.
The cab is not different……. Wherever you got your information, you are incorrect.
Yes, I was partially incorrect. 96 inches wide with mirrors. Cab width on the Raptor is 86.6 inches wide, and the F-150 is 79.9 inches wide. That means the body panels are truly different as I previously stated. Tried to put inner fender liners in it. Won't fit because they're too narrow. Many stampings are unique to the Raptor. Floor pan probably is the same but the rocker panel section is wider than on an F-150. Roof, hood, fenders, cowl, back panel and box are Raptor only I suspect.
Doors and cab are the same. Raptor just has bumpers, Hood, front fenders and rear bedsides. There is no “rocker” panel.
You were more than partially incorrect. Cab width on Raptor is the same 80” as all the other F150s.
