2021+ F-150 FORScan List / Database / Spreadsheet

[rack04]

Regarding this setting:

Enable Heated Steering Wheel on climate bar above

APIM

7D0-02-01

xxxx

*xxx

xx--

see APIM spreadsheet for your value

Can anyone clarify what the Hard Button Controls means?

Sponsored

 

[dolsen]

Regarding this setting:

Enable Heated Steering Wheel on climate bar above

APIM

7D0-02-01

xxxx

*xxx

xx--

see APIM spreadsheet for your value

Can anyone clarify what the Hard Button Controls means?

I have read that several times, and I always took it to mean that if you have a HSW with a button on your HVAC module to control it, then you would use that bit that says "HSW Not Available"

 

[GloverF150]

Can you make a 22 see the front camera at speed?

 

[superfordman]

Regarding this setting:

Enable Heated Steering Wheel on climate bar above

APIM

7D0-02-01

xxxx

*xxx

xx--

see APIM spreadsheet for your value

Can anyone clarify what the Hard Button Controls means?

Would have to verify but 99% sure its to enable this icon when HSW is enabled.

 

[Cheez_Greater]

I have the same issue. I lost the soft button that allows you to switch camera views, even while parked.

That is weird you lost the soft button while parked. What I found is, at speed, pushing the camera button brings up the rear view camera. When I slow down to parking lot speeds, the soft button appears. Then I can change views. If I set the view to the bed camera, turn off the cameras and get to speed then push the camera button, the camera is set to the bed camera and the soft button is available. If I switch to the rear view camera, at speed, then the soft button disappears again.

 

[Tobyson21]

From the speedo thread. Any info/thoughts would be helpful:
Help??

I have gone from 265/60/20 stock Hankook to 275/60/20 more aggressive Cooper Discoverer ATS. When pulling up my info in a 2021 Powerboost, under BdyCM, I look at the appropriate fields but they do not match:

Stated info from OP: 726-15-01 xxxx xxxx ABxx - This field already contains the correct value in my vehicle: xxxx xxxx 09xx (based on code gen, both sizes have this same value present)

Stated info from OP: 726-15-02 CDxx xxx xxxx - This field only has the parameters in 2 segments, ie: F3xx xxxx

Based on my stock configuration, I should have 726-15-01 as: xxxx xxxx 09xx - this is the same for new parameters as that value did not change - OK

What would I change for 726-15-02? My stock parameters are: F3XX xxxx (no 3rd segment) (the stock parameters in the HEX generator suggests that based on 265/60/20, I should be CD- CDxx xxxx xxxx, even though F3 is present on as built parameter)

The Hex generator states I should have F2 as the new value, however when I replace the F3 to the new F2 value, it states that my checksum is wrong, so I did not write The code and perform the DTC check.

Any ideas if the Powerboost BdyCM and 726-15-02 is different on 2021+ and should only contain 2 segments, not 3, and if I write the F2 value vs F3, if this is truly for the tire size?

Thanks in advance.

In summary:
As built on 2021 PowerBoost - came with 265/60/20 Hankooks- Added 275/60/20 Cooper

I have stock configuration:
726-15-01: xxxx xxxx 09xx
726-15-02: F3xx xxxx

Hex builder states I should have stock configuration as:
726-15-01: xxxx xxxx 09xx
726-15-02: CDxx xxxx xxxx

Hex builder with new tires:
726-15-01: xxxx xxxx 09xx
726-15-02: F2xx xxxx

Forscan v2.3.46

I am really curious if this worked? Did you have success?

I have a 2021 Powerboost that I put snow tires on for the winter on 17" base model wheels I bought. I had bought a Flashcal only to learn that it doesn't support Powerboost models. I'm finding a lot of the tuners don't. All I want to do is correct my tire size so my speedo isn't off. I was hoping to do it with a tool, not using Forscan, but I'm not sure I have any options left.

 

[itsdchz]

I am really curious if this worked? Did you have success?

I have a 2021 Powerboost that I put snow tires on for the winter on 17" base model wheels I bought. I had bought a Flashcal only to learn that it doesn't support Powerboost models. I'm finding a lot of the tuners don't. All I want to do is correct my tire size so my speedo isn't off. I was hoping to do it with a tool, not using Forscan, but I'm not sure I have any options left.

Forscan works in this instance for PB. Yes

 

[Bo22F150]

jwgreene, Did you ever get a response to this? Tried putting in an XLT 8in cluster in my STX and received the same error about updating my solenoid strategy number for my transmission. Need to figure this out so I can install the new cluster. Just not finding anything in my searches.

Has anyone had this pop up come up when using Forscan for the first time? It’s wanting me to assign a new transmission solenoid strategy number and says the original is missing.
Any advice?

 

[hotrodmex]

Can you make a 22 see the front camera at speed?

Only in the off-road modes, thanks to the Tremor. It's buried in this thread somewhere.

 

[GloverF150]

Ok so in normal drive mode you are saying you can’t. But in rock crawl mode or something you can even when at speed. Is that correct?

 

[Big Cam]

Ok so in normal drive mode you are saying you can’t. But in rock crawl mode or something you can even when at speed. Is that correct?

Correct. The Forscan change removes the 8mph limit where the front camera used to turn itself off.

In a mode like deep snow/sand/rock crawl mode, the front camera comes on by default with white tire treads to show where your front wheels are going. Doing the change in forscan keeps the camera enabled past 8mph,but only in this specific off road modes where when you turn the dial to it, the camera comes on by default.

It's fun but not as useful as one would think. I made the change and having the screen try to keep up when doing 30mph,its not something you want to look at. Keep your eyes on the road. Haha

 

[hotrodmex]

In a mode like deep snow/sand/rock crawl mode, the front camera comes on by default with white tire treads to show where your front wheels are going.

I'm pretty sure this was stock only on Tremors/Raptors, not on regular F150s. This has to be enabled in FORscan. My factory As Build had cameras at speed already, but I don't remember the camera coming up when switching to Mud&Ruts, and Rock Crawl is also exclusive to Tremor (and Raptor?)

https://www.f150gen14.com/forum/thr...database-spreadsheet.1578/page-62#post-196618

FeatureCfg_DPAC_OffRoadVersion: 00=Disabled 01=Raptor 02=CX430 03=U725

Not sure how @JIMFOUNTAIN figured on 03 instead of 01 or 02, though. I guess the selection that worked?

I always like how this stuff makes me look at the sheet again. I want to know what these all are in the IPMA 706-02-02.

FeatureCfg_DPAC_OffRoadCameraMenu (FCDPACORCM)
FeatureCfg_DPAC_FrontRockCrawl (FCDPACFRC)
FeatureCfg_DPAC_RearRockCrawl (FCDPACRRC)

 

[dolsen]

I'm pretty sure this was stock only on Tremors/Raptors, not on regular F150s. This has to be enabled in FORscan. My factory As Build had cameras at speed already, but I don't remember the camera coming up when switching to Mud&Ruts, and Rock Crawl is also exclusive to Tremor (and Raptor?)

https://www.f150gen14.com/forum/thr...database-spreadsheet.1578/page-62#post-196618

FeatureCfg_DPAC_OffRoadVersion: 00=Disabled 01=Raptor 02=CX430 03=U725

Not sure how @JIMFOUNTAIN figured on 03 instead of 01 or 02, though. I guess the selection that worked?

I always like how this stuff makes me look at the sheet again. I want to know what these all are in the IPMA 706-02-02.

FeatureCfg_DPAC_OffRoadCameraMenu (FCDPACORCM)
FeatureCfg_DPAC_FrontRockCrawl (FCDPACFRC)
FeatureCfg_DPAC_RearRockCrawl (FCDPACRRC)

My 2020 Explorer ST turns on the front cam in rock crawl mode. It came from the factory that way. I'll check my F-150 today.

 

[Big Cam]

I'm pretty sure this was stock only on Tremors/Raptors, not on regular F150s. This has to be enabled in FORscan. My factory As Build had cameras at speed already, but I don't remember the camera coming up when switching to Mud&Ruts, and Rock Crawl is also exclusive to Tremor (and Raptor?)

https://www.f150gen14.com/forum/thr...database-spreadsheet.1578/page-62#post-196618

FeatureCfg_DPAC_OffRoadVersion: 00=Disabled 01=Raptor 02=CX430 03=U725

Not sure how @JIMFOUNTAIN figured on 03 instead of 01 or 02, though. I guess the selection that worked?

I always like how this stuff makes me look at the sheet again. I want to know what these all are in the IPMA 706-02-02.

FeatureCfg_DPAC_OffRoadCameraMenu (FCDPACORCM)
FeatureCfg_DPAC_FrontRockCrawl (FCDPACFRC)
FeatureCfg_DPAC_RearRockCrawl (FCDPACRRC)

I do have a tremor so that is all I know.

 

[JIMFOUNTAIN]

I'm pretty sure this was stock only on Tremors/Raptors, not on regular F150s. This has to be enabled in FORscan. My factory As Build had cameras at speed already, but I don't remember the camera coming up when switching to Mud&Ruts, and Rock Crawl is also exclusive to Tremor (and Raptor?)

https://www.f150gen14.com/forum/thr...database-spreadsheet.1578/page-62#post-196618

FeatureCfg_DPAC_OffRoadVersion: 00=Disabled 01=Raptor 02=CX430 03=U725

Not sure how @JIMFOUNTAIN figured on 03 instead of 01 or 02, though. I guess the selection that worked?

I always like how this stuff makes me look at the sheet again. I want to know what these all are in the IPMA 706-02-02.

FeatureCfg_DPAC_OffRoadCameraMenu (FCDPACORCM)
FeatureCfg_DPAC_FrontRockCrawl (FCDPACFRC)
FeatureCfg_DPAC_RearRockCrawl (FCDPACRRC)

Rock Crawl mode comes with the FX4 package. Also Hill Descent and the dash button. These modes and features can be added later reasonably... Search the threads.

I spent hours using a tool called Asbuilt Explorer looking at Asbuilt configs from Tremor and Raptor VINs. The VINs came from doing inventory searches of Ford dealers and popping up window stickers. Compared the many differences to my Platinum and experimented. I found a combination of 3 changes worked. I then passed what I found to the real heroes around here (@Livnitup , @Jesse-Infotainment , etc.) and they helped me figure out a minimal change and tested other trim levels.

Without the real heroes help (spreadsheet, mapping, tools) it would not have been possible. I was just the grunt doing a lot of analysis/experimentation. These guys have definitely improved my ownership experience... and many, many others. We are very lucky to have them here!

Sponsored