ECU module programming guide using FDRS

[Burner]

What version of sync does the truck say it has?

I just graduated to 22087 Rev 415

Sponsored

 

[JEB]

Well I did the apim/TCU combo update and gwm update that got me to what I think is the equivalent of the 2.4.1 OTA and now there is nothing to update in the sw updates tab. I ran a network test but nothing came up. Any ideas on how long I'll have to wait for the next update to populate in fdrs?

Not really. It’s pretty random. When I did my last APIM, it took two days before I saw another update, which was the GWM. When I did my last updates in December, I didn’t see another for four months.

 

[rugedraw]

I just graduated to 22087 Rev 415

Did you do a network scan after the last update you performed?

 

[Burner]

Did you do a network scan after the last update you performed?

I did run a network scan but nothing came up after

 

[JEB]

Well I just went back and looked at the dialogue boxes. It said not to shut off the ignition unless told to do so, but it never told me to turn it on. Should it be on for this portion? Is it too late to turn it on? The ignition, not the engine

Ordinarily, the ignition should be on. It generally needs to be to do a proper network scan when you open up your session. But I know it says to do it again at the beginning of a module update.

 

[rugedraw]

I did run a network scan but nothing came up after

That is very strange. Sync 22087 is very old software. You should have a plethora of updates there to do. I would close FDRS, re-open it and scan it again.

 

[Jesse-Infotainment]

I just graduated to 22087 Rev 415

What is your vin

 

[rugedraw]

What is your vin

1FTFW1ED6MFB67945

 

[dolsen]

Ordinarily, the ignition should be on. It generally needs to be to do a proper network scan when you open up your session. But I know it says to do it again at the beginning of a module update.

I turned it on to start the session, but the APIM is the 8th update I am doing today, I don't remember why it ended up off during this update. I barely remember what I had for breakfast half of the time haha

 

[Burner]

That is very strange. Sync 22087 is very old software. You should have a plethora of updates there to do. I would close FDRS, re-open it and scan it again.

I just gave that a shot and still have nothing populating

 

[JEB]

I just gave that a shot and still have nothing populating

You can try flushing the cache but it probably won’t make a difference. Click on the envelope in the upper right and one of the options will clear it out.

 

[rugedraw]

I just gave that a shot and still have nothing populating

Give @Jesse-Infotainment a bit to look into it.

 

[Jesse-Infotainment]

I just gave that a shot and still have nothing populating

Your IPC is not updated.

This is the exact reason dealers are not allowed to perform the 21G01

I can sideload it. You would have to allow me to remote in. It will take 6 hours.

 

[Burner]

Your IPC is not updated.

This is the exact reason dealers are not allowed to perform the 21G01

I can sideload it. You would have to allow me to remote in. It will take 6 hours.

Let me know what you need and when you're available I guess. That's a real pain in the ass. What does the sideload process look like?

 

[Jesse-Infotainment]

Let me know what you need and when you're available I guess. That's a real pain in the ass. What does the sideload process look like?

I can do it now. Message me.. I have to remote in via teamviewer.

Sponsored