PB aluminum transmission skid plate.

[ColoradoHunter]

I didn't trust another fiber "skid plate" for the transmission. 1st one didn't last long out hunting in moderate off-roading this fall. After hours of research and calling, nobody offered an aftermarket skid plat that fit the PB. Enter Chris at Hefty Fabworks here in Colorado Springs, www.HeftyFab.com. I dropped my PB off last night, picked it back up at noon. He redesigned his standard F-150 Raptor skid plate, built and installed it this morning along with an engine skid plate. I'm very happy with the quality of his work. He is also in the process of coming up with accessories for the new Bronco. Give him a call.

Sponsored

 

[RossRR]

What was the cost to you?

 

[ColoradoHunter]

What was the cost to you?

Mine was discounted since my truck was used to get the new PB design. I'm not sure what the price will be. Give them a call.

 

[dzacco]

Does this have to be removed to change the oil?

 

[JerseyGlock]

Does this have to be removed to change the oil?

Looks that way, I don't see a cut-out for drain plug.

 

[amschind]

I have the Talons one (I am in Houston so I just drove over and picked it up). They have a cutout for the oil drain plug.

 

[HoustonScrew]

I have the Talons one (I am in Houston so I just drove over and picked it up). They have a cutout for the oil drain plug.

Atascocita here!

 

[FaaWrenchBndr]

Looks that way, I don't see a cut-out for drain plug.

should be able to install a ValvoMax or a Fumoto valve. Either with a hose could be used without having to drop the plate

 

[JerseyGlock]

should be able to install a ValvoMax or a Fumoto valve. Either with a hose could be used without having to drop the plate

No thanks, I'll stick with drain plug and a gasket.

 

[FaaWrenchBndr]

No thanks, I'll stick with drain plug and a gasket.

ok…….

 

[amschind]

No thanks, I'll stick with drain plug and a gasket.

I would strongly encourage you to reconsider. The valve is maybe my favorite mod, and definitely the only one that has actually saved me money. Even pulling the front skid plate to get at the oil filter, it takes me 20 minutes to change my oil now (and I don't have a truck lift, that bougie Snakebitten). The best part is that valve plugs have a hose barb fitting, so you put 6" of hose on it and then getting the oil directed into your drain pan is really easy even if it's windy.

 

[miniceptor86]

I have the fumoto on my 14. Other than the fiddly safety clip which I invariably drop being able to connect a hose to it is a mess saver for diy.

Sponsored