rugedraw
Well-known member
If it's green, then you're fine. Did the TCU come off the list?Tried it several times but still got the same error. I don't see DTC as TCU box shows green. Did I brick my TCU?
Sponsored
If it's green, then you're fine. Did the TCU come off the list?Tried it several times but still got the same error. I don't see DTC as TCU box shows green. Did I brick my TCU?
Yes, sir. I believe one of the TCU update was not completed.What interface cable are you using? Mongoose?
The TCU update is still there. The last round of TCU update was not compltedIf it's green, then you're fine. Did the TCU come off the list?
Battery supply was good. I inserted the USB for update then I left for a while. When I came back, the console screen shows it will shut off. Then I restarted the update which causes the problem.Battery power supply was good the whole time during the update? Computer awake the whole time and good internet too? USB filename something short, 4 letters or less, and formatted EXFAT?
Restart the laptop. If the TCU is still there, reformat the USB, download the files onto it and try again. If it fails again, when fdrs asks if it went through and you select no, it will give you the option to CAN the update. It'll take about an hour and a half, but it'll work.The TCU update is still there. The last round of TCU update was not complted
Thanks man. Tried it. But it doesn't take me to the usb download file step. It stuck in the module config step. My current SYNC version is 22087_PRODUCT. Is this version new enough?Restart the laptop. If the TCU is still there, reformat the USB, download the files onto it and try again. If it fails again, when fdrs asks if it went through and you select no, it will give you the option to CAN the update. It'll take about an hour and a half, but it'll work.
That Sync is very old. You still got several updates for the sync modules to do. You said you restarted the laptop, and FDRS is still stuck in the module config step?Thanks man. Tried it. But it doesn't take me to the usb download file step. It stuck in the module config step. My current SYNC version is 22087_PRODUCT. Is this version new enough?
Yes, FDRS is still stuck in the module config step with error "Procedure Unsuccesful - Cannot Encode HEX".That Sync is very old. You still got several updates for the sync modules to do. You said you restarted the laptop, and FDRS is still stuck in the module config step?
Ugh. This would be so much easier if I had FDRS. Try clicking the TCU in FDRS and try read configuration procedure and lmk what happens.Yes, FDRS is still stuck in the module config step with error "Procedure Unsuccesful - Cannot Encode HEX".
That Sync is very old. You still got several updates for the sync modules to do. You said you restarted the laptop, and FDRS is still stuck in the module config step?
read configuration procedure completed and worked fine. I don’t have a ForscanUgh. This would be so much easier if I had FDRS. Try clicking the TCU in FDRS and try read configuration procedure and lmk what happens.
In the same place you did the read configuration, try the write configuration procedure, too. I'm thinking the TCU updated but the config part failed. Could be an issue on Ford's side. We'll reconvene tomorrow.read configuration procedure completed and worked fine. I don’t have a Forscan