What did you do TO your F-150 today? 🙋🏻‍♂️

[Justinfro]

Clazzio seat covers installed. Will go back and restrecth after a couple of weeks of use. This is my second vehicle to install them on. Cannot speak highly enough as to the fit, durability, and comfort of these things.

Clazzio Seat Covers

Sponsored

 

[Larrymoe]

Auto Start/Stop now defaults to OFF. I can turn it on after I start it. Fat chance.

I've turned mine on exactly once. When I took my truck to get the oil changed. Didn't want the glowing light to arouse any suspicions.

 

[fordtruckman2003]

Clazzio seat covers installed. Will go back and restrecth after a couple of weeks of use. This is my second vehicle to install them on. Cannot speak highly enough as to the fit, durability, and comfort of these things.

Clazzio Seat Covers

Used those on my 2011 and they held up just fine for 12 years. ?

 

[bigblue815]

^how much that run ya if you dont mind me asking. it looks great!

Mine was $800. They coated inside the box frame as well

 

[bigblue815]

Today I had a full paint correction & paint sealant completed in order to eliminate all of the swirls and imperfections. I think it turned out looking phenomenal.

 

[1slo5oh]

Installed a dash cam. To many wackados out there trying to make a quick buck so figured it could be cheap insurance.

 

[Aonarch]

Installed the winch.

Ordered the Factory 55 hook, because this one contacts the bumper as is, even hooked to the recovery hook.

 

[Aonarch]

Created a V1 platform for my fridge and portable battery.

Also installed the Built Right molle panels. Very simple install.

 

[DoughRoller]

Billy meets Steeda

 

[INADAZE]

Billy meets Steeda

Nice! This is my next upgrade after I get the new front Bilstein 4600s installed.

 

[dafuture]

Finally was able to perform the TSB for '22s for the lateral movement "clunk" on my seat pan. Dealer and Ford Engineering Support declined to do it themselves, as they said it wasn't applicable to '23s. A couple bits of heater hose and 2 hose clamps later and my seat finally stopped clunking and clicking around turns and over bumps.

 

[Ford Motor Company]

Billy meets Steeda

Looks great, Linh!

 

[Aonarch]

The Factor 55 hook didn't fit at first. I got annoyed, but then realized, wait the factory hook is a little too small too...

A few forum posts later, it looks like Warn has very poor QC on the factory thimbles. I took a dead blow hammer to it on an anvil, voila! It fits. Cleaned it up, threw on some black spray paint and installed the hook. The Factor 55 hook uses a small spring clip, so if you do this, make sure you have an assortment of spring clip plyers.

 

[Larrymoe]

Got my side windows and front brow tinted. 20% to match the rear window. I like how it turned out.

 

[MJG44]

Finally was able to perform the TSB for '22s for the lateral movement "clunk" on my seat pan. Dealer and Ford Engineering Support declined to do it themselves, as they said it wasn't applicable to '23s. A couple bits of heater hose and 2 hose clamps later and my seat finally stopped clunking and clicking around turns and over bumps.

Have the info for the TDB?
I have the 'clunk' when I decelerate and keep looking to see if I have something rolling under my seat.

Sponsored