Adding Co-Pilot Assist 2.0 with Forscan?

[mrtull]

Yes, if you replace the bumper harness with the new one that connector will be there. Make sure you're prewired at the IPMA connector first, if so you'll just need the bumper harness.

Thanks for the reminder.... I checked once and confirmed I had them but I'll likely check again just to make sure.

Sponsored

 

[Oakstone]

One last sanity check before I push the "Pay Now" button for the parts!

I have a Powerboost, so just ensuring that it is indeed the same MA harness that has been referenced.

I've verified the wires to the bumper from the IPMA.

Look correct?

 

[superfordman]

One last sanity check before I push the "Pay Now" button for the parts!

I have a Powerboost, so just ensuring that it is indeed the same MA harness that has been referenced.

I've verified the wires to the bumper from the IPMA.

Look correct?

Yep, you got it. I'm not familiar with that bolt, its just a basic 10mm flange bolts that hold it in so nothing fancy.

I'd highly suggest the steering wheel switch as well as you'll most likely want it eventually to adjust distance.

 

[Oakstone]

Yep, you got it. I'm not familiar with that bolt, its just a basic 10mm flange bolts that hold it in so nothing fancy.

I'd highly suggest the steering wheel switch as well as you'll most likely want it eventually to adjust distance.

I’m a little leery of mucking with the wheel haha. But I guess it can’t hurt to throw it in the order for when I get braver.

 

[Oakstone]

Allrighty, parts are on the way! My friend who is going to help me is keen to try the switch at the same time, so I guess we're all in haha

 

[ReverendQ]

Allrighty, parts are on the way! My friend who is going to help me is keen to try the switch at the same time, so I guess we're all in haha

@Oakstone , I got a sheepish grin when I read your trepidation about the steering wheel switch. I was right there myself, see posts #699 and then #700. Hopefully it will provide you with the comfort to proceed confidently.

 

[mrtull]

I’m a little leery of mucking with the wheel haha. But I guess it can’t hurt to throw it in the order for when I get braver.

Same hesitation here. I want to do it because it feels incomplete if I don't.

 

[Oakstone]

Same hesitation here. I want to do it because it feels incomplete if I don't.

After watching some videos I’m feeling a lot more confident. I’m the same in wanting it to feel complete. I added rain sensing wipers and replaced the wiper stalk just for the little silkscreened “A” at the bottom haha.

 

[mrtull]

I added rain sensing wipers and replaced the wiper stalk just for the little silkscreened “A” at the bottom haha.

? I bookmarked a thread on this because I was thinking it would be icing on the cake. I'm still bummed I have to replace IPMA to get front sensors so trying to console myself

 

[Oakstone]

? I bookmarked a thread on this because I was thinking it would be icing on the cake. I'm still bummed I have to replace IPMA to get front sensors so trying to console myself

Yeah me too. Strange to get the 360 cams and not the chips for the front sensors. I am going to pass on replacing the IPMA.

Boy I wish when they informed me of my Nav Delete that I asked more deeply about other features. The dealer said nothing else was affected and even left Cruise 2.0 on my invoice lol. They didn’t know it was missing until I was doing the pickup and said “uhh where the cruise gap button?”

If given the option of waiting a few more months to get the actual truck I ordered, I would have preferred that to the “deleted” version, especially considering I had never bought a new vehicle before and figured I’d do a bit of a once in a lifetime custom order.

 

[Oakstone]

@superfordman

I was backing up all my As-Built's today in preparation for getting things going and figured I'd troll through the easy-mode settings to make sure I understood and could find everything from your spreadsheet. I'm a bit confused about some of the settings highlighted in green.

Am I looking for the bold words on the sheet for the plain English from the easy-mode menus?

ABS - I don't seem to have an "easy mode" for ABS, just an as-built selection. Is this expected or should I see a "module configuration" next to the as-built?

APIM - Electric Horizon - There is nothing called this in the easy-mode menu. Does it activate when I enable something else like TSR?

I get especially lost at the IPMA. Are you using shortened acronyms for the words here? For example, the first line item in the screenshot below, would I be looking for "distance alert"?

The second one, am I looking for Traffic Sign Recognition (change to SLIF) and Intelligent Adaptive Cruise Control (change to enabled)?

Third one I am guessing is Traffic Jam Assist?

The one below that I'm totally stumped. TAD? EMH?

I've made a bunch of other Forscan changes following your "common" easy mode stuff, but just want to be very careful with this mod.

Thanks!

 

[ReverendQ]

@superfordman

I was backing up all my As-Built's today in preparation for getting things going and figured I'd troll through the easy-mode settings to make sure I understood and could find everything from your spreadsheet. I'm a bit confused about some of the settings highlighted in green.

Am I looking for the bold words on the sheet for the plain English from the easy-mode menus?

ABS - I don't seem to have an "easy mode" for ABS, just an as-built selection. Is this expected or should I see a "module configuration" next to the as-built?

APIM - Electric Horizon - There is nothing called this in the easy-mode menu. Does it activate when I enable something else like TSR?

I get especially lost at the IPMA. Are you using shortened acronyms for the words here? For example, the first line item in the screenshot below, would I be looking for "distance alert"?

The second one, am I looking for Traffic Sign Recognition (change to SLIF) and Intelligent Adaptive Cruise Control (change to enabled)?

Third one I am guessing is Traffic Jam Assist?

The one below that I'm totally stumped. TAD? EMH?

I've made a bunch of other Forscan changes following your "common" easy mode stuff, but just want to be very careful with this mod.

Thanks!

Oakstone,
Do your backups of AsBuilt, not Easy Mode. I suggest take a moment and get all of them, not just what will be changing. Also, get the total file from the Motocraft site. And if really curious, get a program called AsBuilt Explorer and start looking at the files vs. the spreadsheet.
I sent you my changes when gonig through this progress since I too have a 302A.
Good luck, ReverendQ

 

[Oakstone]

Oakstone,
Do your backups of AsBuilt, not Easy Mode. I suggest take a moment and get all of them, not just what will be changing. Also, get the total file from the Motocraft site. And if really curious, get a program called AsBuilt Explorer and start looking at the files vs. the spreadsheet.
I sent you my changes when gonig through this progress since I too have a 302A.
Good luck, ReverendQ

Cool thanks!

I did save all my as builts as the backup, including the modules not included. I have a bunch of existing changes like silent mode, remote windows, etc that I want to take a snapshot of before I do the IACC.

 

[ReverendQ]

Good idea ...

 

[superfordman]

@superfordman

I was backing up all my As-Built's today in preparation for getting things going and figured I'd troll through the easy-mode settings to make sure I understood and could find everything from your spreadsheet. I'm a bit confused about some of the settings highlighted in green.

Am I looking for the bold words on the sheet for the plain English from the easy-mode menus?
Yes, it is a bit tricky since I didn't put the actual term in there since we started from all asbuilt changes at the beginning then more easy mode changes became available to utilize.

ABS - I don't seem to have an "easy mode" for ABS, just an as-built selection. Is this expected or should I see a "module configuration" next to the as-built?
There isn't one so you need to modify the asbuilt.

APIM - Electric Horizon - There is nothing called this in the easy-mode menu. Does it activate when I enable something else like TSR?
Another one that needs to be change in the asbuilt.

I get especially lost at the IPMA. Are you using shortened acronyms for the words here? For example, the first line item in the screenshot below, would I be looking for "distance alert"?
This is all straight out of the main forscan sheet so takes some getting use to and interpretation.

The second one, am I looking for Traffic Sign Recognition (change to SLIF) and Intelligent Adaptive Cruise Control (change to enabled)?

Third one I am guessing is Traffic Jam Assist?
Yes, you have all those correct.

The one below that I'm totally stumped. TAD? EMH?
I'm not even sure what these two are but they need enabled to make everything work.


I've made a bunch of other Forscan changes following your "common" easy mode stuff, but just want to be very careful with this mod.

Thanks!

You're on the right path, you just need to familiarize yourself with the main forscan sheet as all of this is straight from that. If there isn't an easy mode change, you need to modify the asbuilt to enabled the bolded feature for your asbuilt. Don't just put in my suggested change if your is different to start.

Sponsored