Unsure of the length as I haven't done it yet, but I recall a minimum of 10ga wire. Also, a correctly sized ring terminal will be fine for your ground connection.
That's great! Do you mind sharing the parts you had to replace/order for this mod? New streering wheel? New clock spring? Wiring harness?I would like to thank everyone for all the information shared here.
Yesterday I was able to put the Steering Wheel, the HVAC controller and the harness that was needed to turn on my HSW and my Paddle Shifters.
Thanks to @BarryT82 for supplying the Steering Wheel, @Jesse-Infotainment for always being super helpful, @superfordman and @DK4.
I Love it now.
@dolsen is correct, but if you just want to add the heated wheel button to the touch screen via forscan, and you also want the led temperature display on the HVAC knobs for an XLT with dual zone climate and heated seats (but not cooled), ML3Z-19980-B is the part number you want.
I believe that the SCCM cannot be bought without a wiper stalk already attached, but depending on if you have auto wipers, you might have to switch stalks. The SCCM also does not seem to come with the adjustment button for power adjustable steering wheel, but again, that can just be put on. I currently have an SCCM and wiring harness I purchased from Boosted Grey Goose, and the SCCM came with a wiper stalk, but I will need to swap it. My truck should finally be ready for me to pick up next week, so eventually I will get to doing this install, likely late Mar.
Does that mean your truck will have everything except for the correct SCCM? In that case, is the only part you need the correct SCCM with pins, and you just need to swap the SCCM and connect all wires? I hope that is the case!
That is what I am thinking based on what I have seen from others who have taken delivery of 402a and above 23's. If not I have all of the other parts, but less work is less work.
Is there another thread for these reports? I'd love to subscribe to that thread.
