cary
Well-known member
Mine doesn’t even show in the tiles section. I guess it’s broken.Got it. I thought I saw it at one point and I recall seeing it in photos. My curiosity was getting to me. Thanks.
Sponsored
Mine doesn’t even show in the tiles section. I guess it’s broken.Got it. I thought I saw it at one point and I recall seeing it in photos. My curiosity was getting to me. Thanks.
I think it's Android only, because I got it, too.not seeing it on iOS :/
CorrectWill only show top right until you activate it then it’ll go away. Alexa should still be in your settings tile though.
How’s the cell reception at you place? My activation of Alexa, BC and NAV wouldn’t come through until I went somewhere with decent service. Wifi didn’t help either.Mine doesn’t even show in the tiles section. I guess it’s broken.
@Jesse-Infotainment check @cary For IPC software, his screen shot this morning showed the old version i think...Mine doesn’t even show in the tiles section. I guess it’s broken.
Not working on mine either. I’ve tried everything to get it to show up. It’s shows activation pending in Fordpass.
He has an XLT. So his is different than OUrs.@Jesse-Infotainment check @cary For IPC software, his screen shot this morning showed the old version i think...
Thank youHow’s the cell reception at you place? My activation of Alexa, BC and NAV wouldn’t come through until I went somewhere with decent service. Wifi didn’t help either.
also notice that being in CarPlay may surpress the activation message for FP if anyone is having that issue.
Easy peasy update. Give yourself lots of time though and when it says to restart your truck to finish open the window, turn it off, close the doors, take your keys out and give it a good 30 minutes minimum to make sure it’s done. When complete if you just look in without opening the doors none of the USB lights or the front control button LEDs underneath the APIM should be on or flashing. Needs to be completely dark.starting the latest APIM now. wish me luck. had a misfire on a trip out west towing the airstream so the dealer in NM updated all modules except APIM… haha
thanks. yea i’ve done many updates before and have my routine downEasy peasy update. Give yourself lots of time though and when it says to restart your truck to finish open the window, turn it off, close the doors, take your keys out and give it a good 30 minutes minimum to make sure it’s done. When complete if you just look in without opening the doors none of the USB lights or the front control button LEDs underneath the APIM should be on or flashing. Needs to be completely dark.
I really don't know why that isn't standard across all varients, even if you have the temp on your dial.HVAC Interior Temps in Upper Corners
7D0-02-02
4X1X XXXX XXXX
They were misaligned on their software. Hardware wise most if not all variants supported it but until this latest release they weren’t able to pull it across and display it on J1 builds.I really don't know why that isn't standard across all varients, even if you have the temp on your dial.
Think your reply was meant for someone else?If you don’t see the Alexa Icon in sync I know a master reset worked for me. Also don’t forget to remove your truck from the app first, remove it from your Bluetooth and CarPlay/Auto before doing the reset.
Sucks yes because you need to set everything back up. Also what’s cell service like where you are? That sometimes can delay it if the signal is low and the truck can’t reach the mothership. Don’t rely on wifi because I don’t think Ford has fully implemented it yet.
Oh probably… too much going on today and the squirrel ?️ may have come out in me. Thanks for letting me know.Think your reply was meant for someone else?
I had no problem. Everything worked fine. It's not about the cell service because Ford uses their own. Prob ATT. Mine is parked next to my garage and hooked up to wifi. I used FDRS to do it all.