0.5" or 1.5" level kit

[littlehandegan]

Anyone running the 0.5 or 1.5 leveling kit?

Sponsored

 

[RedundanT]

Lots of folks, just take out the rear block and you have about 1.25" drop. If you're going to run stock or slightly larger size tires why hoist the front end up in the air to match the ludicrously high rear?

 

[Static]

Something to consider, not sure what your desired outcome is, but I was looking at doing a 1 to 1.5 inch level because I didn't want to be completely even front to back. Ended up with a 2 inch level and I don't think I'd have been happy with anything less than 2 now that I see it.

 

[DMuiser]

1.5” motofab leveling kit on a ‘21 powerboost. New rubber next week.

 

[Rockman5159]

Anyone running the 0.5 or 1.5 leveling kit?

I also have the 1.5 motofab spacers in my 2021 rcswb FX4 . IMO on a reg cab its just right.

 

[Zengineer]

Lots of folks, just take out the rear block and you have about 1.25" drop. If you're going to run stock or slightly larger size tires why hoist the front end up in the air to match the ludicrously high rear?

I agree and have gone this route on several trucks, but I don't think there are "lots" who do this. It's more a DIY thing and not something a dealer or independent shop could make money on from those who just write a check to get "leveled"...as if putting a spacer in the front is somehow a big deal compared to taking one out in the rear.

Sponsored