Show off your MagSafe phone charger mounts

[Buyer2021]

Here's mine, details here, installed in my new console cubby while doing a console-to-column shifter conversion (I do not use my phone for anything that requires other than Bluetooth connection with the truck). As much as anything it keeps the phone in a tidy place even if charging isn't needed:

Sponsored

 

[Porpoise Hork]

Finally got around to testing my 3d printed Magsafe mount and the prototype fits perfectly! It's a snug fit so no sliding or rattles, but you could put some cloth tape around the edge if you wanted. I printed this out of Polymaker HT-PLA and so far no issues. If it warps I'll reprint it with PET-CF to better handle the heat.

I have two versions of the model posted STL on Printables. One with a notch in the front center and one without.

https://www.printables.com/model/1489977-f150-magsafe-phone-mount

 

[Pawheel]

Course mount. I can use it with my hand resting on the shifter.

https://coursemotorsports.com/produ...kg9JwNpf-ClWbnMIinop0o5-LrjQQOwXRclaW8WS6_gx-

 

[Mosey]

Finally got around to testing my 3d printed Magsafe mount and the prototype fits perfectly! It's a snug fit so no sliding or rattles, but you could put some cloth tape around the edge if you wanted. I printed this out of Polymaker HT-PLA and so far no issues. If it warps I'll reprint it with PET-CF to better handle the heat.

I have two versions of the model posted STL on Printables. One with a notch in the front center and one without.

https://www.printables.com/model/1489977-f150-magsafe-phone-mount

Are you will to post your CAD file?

 

[Porpoise Hork]

I made it in TinkerCad. Unfortunately it only exports to .OBJ, STL and .GLTF formats. LMK if one of those other formats will work for you and I can add it to Printables.

 

[Mosey]

I made it in TinkerCad. Unfortunately it only exports to .OBJ, STL and .GLTF formats. LMK if one of those other formats will work for you and I can add it to Printables.

I probably should have looked first. Solidworks can open STL files.

 

[NitroDarwin]

Bulletpoint with a different usb magsafe charger then have a 30w usb c plug hardwired behind the glovebox and into the fuse panel. Everything is completely removable and the only way you could tell something was installed is if you were to lift the rubber mat.

Any more information on how you hardwired this setup? Please

Sponsored