Reverse Mirror Dip / Tip ?

[Zyvin]

I got mine to kinda work. Same as BCrisp above.

It seemed to work correctly once then the next time it just keeps trying to go down continuously “clicking”. I tried the old method of calibration as well.

Sponsored

 

[astrand1]

IF ANYONE IS STILL TRYING TO MAKE THIS WORK LET ME KNOW I THINK I FOUND WHAT WE NEEDD TO ADD TO MAKE IT WORK.

id be interested in this as well. Will it work with powerfold mirrors on an XLT?

 

[ENG430]

IF ANYONE IS STILL TRYING TO MAKE THIS WORK LET ME KNOW I THINK I FOUND WHAT WE NEEDD TO ADD TO MAKE IT WORK.

I'm interesting too

 

[zacko11288]

IF ANYONE IS STILL TRYING TO MAKE THIS WORK LET ME KNOW I THINK I FOUND WHAT WE NEEDD TO ADD TO MAKE IT WORK.

I'm interested in getting this to work if you have a solution. Thanks!

 

[Jesse-Infotainment]

I'm interested in getting this to work if you have a solution. Thanks!

No.. it didnt work.. sorry

 

[mdomicolo]

Did anyone figure this out yet?! ?

 

[yamahadrtrdr]

Digging this one back up, I enabled the setting in APIM. It shows up in vehicle settings, when you put the truck in reverse and select a mirror on the mirrow adjustment buttons they start to go down but keep going and "click". It's like it's missing a calibration or something.

 

[rugedraw]

Digging this one back up, I enabled the setting in APIM. It shows up in vehicle settings, when you put the truck in reverse and select a mirror on the mirrow adjustment buttons they start to go down but keep going and "click". It's like it's missing a calibration or something.

If @Jesse-Infotainment says it won't work, then it won't work. However, it was over two years ago, so maybe newer software has been released for the relevant modules that allow it work?

Funny....I was just talking to @Yank about this a little while ago and I was telling him I thought it was possible. Apparently, it may not be as easy I thought.

Sponsored