removed

[Deleted member 12573]

content removed.

Sponsored

 

[22XLT]

Do you think those size tires would have been fine without the leveling kit?

 

[Bandit Heeler]

Nice set up Where did you find the flag decals for you side vents?

 

[Rockman5159]

2 inch Ready Lift level(rear was still 1 1/4” higher than the front ) Nexen AT Pro RA8 285/75r17. Speedometer only seems to be off at higher speeds 55 and above, lower and it’s in line with the gps. View attachment 66529 View attachment 66530 View attachment 66531 Nice stance and pretty truck. RCSB trucks are my favorite

 

[22XLT]

OK I didn’t realize those were 33”plus diameter.

I was looking at 285/70/17s for myself. I mis-read 75 part of that.

Are you happy with the level or do you wish it took a little more rake out of the stance?

It seems like I can’t un-see the rake in my stock set up.

 

[9663mu]

That’s a bad ass set up! Very cool looking. I use this
https://www.tacomaworld.com/tirecalc

 

[22XLT]

Pre-level my rake was 3 1/4" difference and like you I hated the look. After the level only a 1 1/4 difference. When the tech drove it around the lot, I had a big ole smile. The truck finally had the correct stance for my liking.

Where did you get an install done at?

I'm curious what something like that would cost and if you were concerned about any issues with might be "factory warranty effecting" which is mainly my hangup.

I see they offer kits out there that include an upper control arm that might correct some of the geometry a little better. So not sure if something like that crossed your mind when deciding what to get.

Sponsored