14th Gen Console LID Fix (3D Print Solution) - Not a nickle....!

[dykzeulb]

3d printed these to make something a little more solid than the double nickle console lid fix. In black they just disappear. Lid stays up with zero issues now! (NOW ON Thingiverse)

https://www.thingiverse.com/thing:7096259

I am not trying to make any cash on these, but I will most certainly make you some as I am sure other members would with printers.

Sponsored

 

[moritzes]

Cooly done!

 

[jhelrey]

Another reason to buy a 3D printer.

 

[dykzeulb]

Another reason to buy a 3D printer.

The rear seat vent extensions were my justification!
?

 

[Porpoise Hork]

Very nice. Any possible chance you could upload the plain STL file for it? Orca is being argumentative because the file's embedded gcode for a different printer.

 

[dykzeulb]

Very nice. Any possible chance you could upload the plain STL file for it? Orca is being argumentative because the file's embedded gcode for a different printer.

I’ll see if I can this evening when we wrap up softball tournaments!

 

[Porpoise Hork]

Thanks! That'd be great and no rush on it sir.

 

[dykzeulb]

Thanks! That'd be great and no rush on it sir.

Just need to get a Bambu H2D! ?

 

[Porpoise Hork]

Thought about getting one but the wife would kill me if I spent that kind of money on a new printer lol.

 

[BarryT82]

I need to print these and the piece that keeps the console tray from sliding.

 

[Jeff1024]

I need to print these and the piece that keeps the console tray from sliding.

Do you have a link to the .stl for the design that keeps the tray from sliding?

 

[Jeff1024]

Very nice. Any possible chance you could upload the plain STL file for it? Orca is being argumentative because the file's embedded gcode for a different printer.

Cura didnt love the file either, I hate to be demanding but could you try to re-upload to thingaverse or post the .stl here?

Would love to get this printed for sure!

 

[MBabs382]

I purchased a Toybox printer for “my son”. It’s an easy jumping off point for 3D printing for beginners. And my son actually uses it. Who knew. Any way… these can be easily printed but my advice is to print them solid (100% infill).

 

[dykzeulb]

I need to print these and the piece that keeps the console tray from sliding.

The sliding piece is a godsend as well! I went with a full tray from Amazon as even with the pieces it still slid a few mms and made that annoying clunk

 

[dykzeulb]

I purchased a Toybox printer for “my son”. It’s an easy jumping off point for 3D printing for beginners. And my son actually uses it. Who knew. Any way… these can be easily printed but my advice is to print them solid (100% infill).

Absolutely, the ones I have been printing from others have been PETG 100% infill and held up well!

Sponsored