Search results

Anyone have a dyno graph comparing these to stock turbos? I have no doubts the bigger wheels will move more air; what concerns me are the stock housings. The stock exhaust and compressor housings can only flow so much air, regardless of what size the wheels inside the turbos are. I realize they...

I think the OP is more concerned with future tire rotations VS initial install. I use a breaker bar to break all of mine loose and then use an impact to buzz them off. I also use the impact to put them back on but I don't apply much torque once it's seated, finish it off with a torque wrench.

How does it ride compared to the stock suspension?

Truck looks perfect, well done. Great choice on tire size, while 35s look good on these trucks, 33s look absolutely perfect with a 2 inch(ish) lift.

Retired USAF, 21 years in Aircraft Maintenance Currently Civil Service doing Logistics

Truck looks great, please post your suspension setup.

These cowl drains clog up very easily. Every time I wash the truck I make sure I clean those areas really well, this includes the entire cowl. Also, whenever I walk by I try to clear off any leaves or debris that settles there.

Valve stem seals are the likely culprit.

Spare tire lock, prevent someone from lowering your spare and stealing it. Used to be standard but Ford is holding out on us.

Drain tubes for your tonneau cover rails.

The 3.5 comes standard with those models. It sounds like Ford chose which shroud to use based on the standard engine for each trim level vs choosing the shroud based off engine selection alone.

I could be wrong on this but I thought the issue with the panel lifting and deforming was only on Raptor models. When this has happened you could see the push pins pulled out from the shroud, I don't think anyone has reported pulled pins on the 24 power boost models. I'm not sure who it was...

Whipple updated the rotor profiles making them more efficient on the gen 6, especially when they are spun very hard (high boost applications).

In Virginia, cops used to pull you over for tint and no front plate. I'm not sure if the laws have changed but ever since covid these have basically become secondary offenses. As to others pointing out your tint is illegal, if I was in a really good mood I would probably say thank you for...

This may be a dumb question but can someone explain why this does not affect the non-power boost 3.5?

Yes, once you insert the screwdriver into the hole it will engage the gears. Turn the screwdriver counterclockwise to lower your beam pattern.

I don't have first hand experience with the 3.5 but have played with several Coyotes over the years. From the sounds of it all of your exhaust bolts are tight. Have you ensured you have enough clearance around all of your exhaust pipes? Sometimes under load when the engine flexes the exhaust...

All spacer lifts will ride very similar to OEM, there are tons of companies who offer these and they are cheap.

I have experienced this issue in multiple cars. On short trips I generally leave the a/c on all the time. If I know the car will stay parked for awhile I turn the a/c off about one minute before I turn the vehicle off. I've been using this method for several years and no issues. The above...

The McGards are top knotch, I ran them on my previous RAM 2500 with no issues. They are pricey but they will hold up. The Ford Performance lugs are indeed a two piece design. They look identical to the stock lugs but they are black. Like I said if you have Ford pass points the Ford lugs are...