yes, I found that, but it doesn't list those features. No mention I can find of CCD.
On my ‘25 Tremor, you push one of the buttons on the side of the shifter to display the gear counter…
Same for my 2025 KR.
Longshot but figured I'd try. I've seen many posts with @Jesse-Infotainment having the inside scoop on these 150's. If you happen to come across one of the revised 25's could you please provide us early 25 owners with the needed part numbers required to retro fit the Job 2 revised look. Can't seem to find anything on Ford parts. Many with the big ugly blank button would greatly appreciate it!Hey Guys, hoping you can help. Many of us who bought the Job 1 25MY are left with the ugly blank plate filling the hole where Ford deleted many of the usual buttons above the Sync screen. Thanks to a Post by @Abraham5G, we see now that Ford has done the right thing, replaced the blank with a much better solution, and centered the remaining buttons. I'd really like to know what these needed part numbers would be to replace the ugly big blank plate and lens on the J1 with the new lens like the J2. Can anyone help with part numbers? Would the J1 folks be able to just put our existing buttons into the new lens that holds the buttons and achieve the new and improved centered look?
Looking on Ford Parts website, I can't seem to locate the black lens that holds the buttons. Even if someone could tell me where it might be found on the website or the part name, that would be helpful. thought for sure it would be in the FORD PARTS / BODY / INSTRUMENT PANELS section, but I had no luck.
Any help is much appreciated!!
2025 JOB 2
2025 JOB 1
Actually, I see @Abraham5G is from Houston, started searching dealer inventory in that area and found this one! Let's try to figure out these part numbers used on the VIN below.
VIN: 1FTFW1RG7SFA69718
Link to dealer site, the images are renderings, but they do show the update button config, there's hope!
Dealer Website with Job 2 Raptor
EDIT: Well crap, that VIN doesn't even register on Ford Parts website
So this is the actual back view of that set up on the bottom of the photo? You're saying just changing the lens? Please tell me you have a part number for that lens? The two sensors on the far left and far right of the lens those can be just reused from the job one trucks? What about the buttons in the middle? The right button on job one trucks will have a flat side to the far right where the job two have an angled on the left side and right side of the two button. Really appreciate you sharing this and any other information you have.The main panel is the same. They just added that new lense to the front to clean it up and retain the CMR.
I am sure you would need a new button to fit the lens. I do not have a part number for the lens. I highly doubt you can actually purchase it separately. I just happen to find the panel on Ebay.
Dang, thats big bucks for the lens. So close, yet so far away. It looks to me like this part number could be used with the lens alone to get the angled button on the hill descent. The covers appear to just pop off/on. Never tried.
