What did you do TO your F-150 today? 🙋🏻‍♂️

[Escape Hatch]

Finally updated my tire size in Forscan after four months but what puzzles me is the previous size was listed as 25XX which is a 32 inches tire. I have a Tremor which should have been 2644mm for the 275/70r18 General Grabber.

Sponsored

 

[RGS88]

Hauled some stuff for my mom, then went and got my new wheels installed. Much happier with the all black wheels.

 

[Ford Motor Company]

Just this week I got new tires (General Grabber ATX)--lead to trimming front air dam, oil change, transmission fluid exchange and alignment. Previously I swapped to a short antenna and put in the Rough Country rear fender well liners as well as a tonneau cover.

Your F-150 looks really nice, Buddy!

 

[HammaMan]

Finally updated my tire size in Forscan after four months but what puzzles me is the previous size was listed as 25XX which is a 32 inches tire. I have a Tremor which should have been 2644mm for the 275/70r18 General Grabber.

Don't forget the .967 multiplier for rolling diameter

 

[Kidder]

My truck went into Ecoroost mode to get new tires. My truck has 58k miles and the OEM Goodyear Wrangler Territory were done.

 

[FaaWrenchBndr]

Decided to give BlueCruise another shot………monthly

 

[oncechance]

New oil, filter, air filter and cabin filter. I also installed the ValvoMax drain plug.

 

[Aonarch]

Installed the Rough Country Hidden winch mount from the 13th gen. It was a major pain in the ass to drill out the four additional slots needed. It's very thick steel. A laser table or a plasma torch would have made light work out of it, but I had to rely on drill bits, step up bits, a grinder, and a Dremel with a cut off wheel. Took me hours.

I realized while mocking everything up, that it would actually be easier to install the winch with a transmission jack after mounting up the plate. Plus it turned out that I actually have to do that due to clearance issues, the winch won't slide in between the frame horns where the bumper bolts to, but it has plenty of room to be installed vertically from the bottom.

So for now, no winch installed, just the mount, which was 95% of the job. I'll install the winch later, maybe next weekend, or wait to borrow a transmission/ motorcycle jack.

The factory cabin filter let every smell into the cabin. Upgraded to this Wix filter that is much higher quality. Big improvement.

 

[Johnland25]

Tried plugging a 110 into the dash today of my 2024 STX. What clown on the design board decided to make two usbc outlets look exactly like a normal one?

 

[Nevadajack]

My truck went into Ecoroost mode to get new tires. My truck has 58k miles and the OEM Goodyear Wrangler Territory were done.

Put those same Coopers on my truck...very happy with them.

 

[Pintoracer]

Toughskinz letters!

 

[fordtruckman2003]

Tried plugging a 110 into the dash today of my 2024 STX. What clown on the design board decided to make two usbc outlets look exactly like a normal one?

I'm just impressed you have USB C on an STX.

 

[Fox146]

Well it’s that time of year again. Swapped out the summer 22s for the winter 20s. Fresh oil / filter as well, and cleaned the Foxes while the wheels were off. Time for a wash

 

[Ricksc]

Moved the front license plate off to the left. So it’s not blocking the airflow to the intercooler. Better safe than sorry.

 

[Ricksc]

Also added the Cobb radiator cover dumping fords rubber one.

Sponsored