So what IS the latest/current Sync4 version?

[Snakebitten]

Sounds like you have your priorities right!

Cheers to your son's birthday good sir.

Sponsored

 

[Kanuck]

I was thinking...and yes thinking gives me a headache..... but it is too bad that all was needed is to load a file on a USB stick and plug it into the truck. Tell the truck to load the file and update. The truck would then run the install routine which would do a back up of the module to the USB stick and load the new file. Similar to updating the Sync 3 firmware. But that would really tick off the dealers with us doing it ourselves.

Just a thought... and I know that it will never happen...but...

 

[RalpL]

I have no recommendations, the dealer wont follow them. The IPMA was fine it didnt need to be replaced. They are too stupid to understand.

THe new IPMA needs to be programmed and they are too stupid to understand. They think a Linbus initialization will do that. THey are hopeless.

Ford

Picked up my truck from the dealer. They even showed me the proprietary correspondence between the tech and Ford Engineering where they admit the download issues being reported by dealers and they don't have a solution yet. Went in for a Rear Brake Assist Not Available dash warning and alarm. After replacing the rear camera and two modules as directed by Ford Engineering, I still have the warning. I'll post the work order when I get home over the weekend which lists the part numbers for the modules.

After medical issues and surgery, I'm finally posting my dealer work order on their attempted repair of my Rear Brake Assist Not Available dash warning. I still have the warning... ? Does the work they did make sense? BTW - still Sync4 Version 21297 Revision 253 with no OTA updates.

 

[Jesse-Infotainment]

After medical issues and surgery, I'm finally posting my dealer work order on their attempted repair of my Rear Brake Assist Not Available dash warning. I still have the warning... ? Does the work they did make sense? BTW - still Sync4 Version 21297 Revision 253 with no OTA updates.

If you still have the warning they didnt complete the 360 camera alignment properly. Ill need your vin to look at it more specifically. Youll need to have the alignment done properly to get that message to go away.

 

[RalpL]

If you still have the warning they didnt complete the 360 camera alignment properly. Ill need your vin to look at it more specifically. Youll need to have the alignment done properly to get that message to go away.

Thanks for the feedback. It seems like they're doing everything but that! They kept the truck 10 days when I took it in that time. At least they gave me a rental.

 

[Mauimaikai]

After medical issues and surgery

I hope you have a healthy and speedy recovery.

 

[mschiraldi]

After a marathon of updates on a 2 day FDRS my Job 1 501a is Version 22192 Rev 498. Anyone else have that? Software updates still says “You’re all set” I have cameras in motion full screen and activated via Forscan in cards. No Alexa.

 

[a4techpl]

After a marathon of updates on a 2 day FDRS my Job 1 501a is Version 22192 Rev 498. Anyone else have that? Software updates still says “You’re all set” I have cameras in motion full screen and activated via Forscan in cards. No Alexa.

Can You share Your fin or check PTS for part number of new SW ?

Mu5T-14G682-XX ?

 

[mschiraldi]

Can You share Your fin or check PTS for part number of new SW ?

Mu5T-14G682-XX ?

PM sent.

 

[Mattman]

After a marathon of updates on a 2 day FDRS my Job 1 501a is Version 22192 Rev 498. Anyone else have that? Software updates still says “You’re all set” I have cameras in motion full screen and activated via Forscan in cards. No Alexa.

I have the same after FDRS updates. Although I’ve never used Forscan on my F150, I have full cams in motion and the bed cam in the side tile.

 

[JohnDen]

What does this mean?

My FordPass is active.
Vin# 1FTFW1ED8MFB23607

 

[tonesto7]

Not gonna lie I'm hoping they don't push out updates for Job 1's anytime soon beyond getting to Blue Cruise level. I feel like Sync is in a good spot with build 22034

Don't worry v22228 is absolutely wonderful and runs pretty great even with Alexa enabled

 

[speedracercjr]

Don't worry v22228 is absolutely wonderful and runs pretty great even with Alexa enabled

haha that was a long time ago! You’re right 22228 is a pretty solid build!

 

[nezff]

So what's the latest and or best. I'll check mine tonight

 

[Jmendoza]

So what's the latest and or best. I'll check mine tonight

22293

Sponsored