Rough Country Power Running Boards (e steps)

[Jmitchelltfo]

I actually ran it under the truck through one of the cross members and then up through a plug under the drivers floor board. Didn’t want to have to deal with all the other interior stuff.

Just to clarify......
You ran everything from the passenger side to the driver's side through the cross member and up through the grommet?




I wonder why RC wouldn't simplify their install directions and just tell everyone to do it that way.
I'll be doing my install this afternoon and have my fish tape on standby to pull everything through!

Sponsored

 

[Soc4me]

Just to clarify......
You ran everything from the passenger side to the driver's side through the cross member and up through the grommet?




I wonder why RC wouldn't simplify their install directions and just tell everyone to do it that way.
I'll be doing my install this afternoon and have my fish tape on standby to pull everything through!

Not sure. I just thought that running it through the cross member would add some protection to the wires. Time will tell if I was correct or not.

 

[Jmitchelltfo]

Not sure. I just thought that running it through the cross member would add some protection to the wires. Time will tell if I was correct or not.

I spent 45 minutes re-working the wiring harness to account for the change to run everything except the brown wire to the drivers side.

After all that work I still don’t know why the lights won’t come on. Everything else works perfect.

 

[Soc4me]

I spent 45 minutes re-working the wiring harness to account for the change to run everything except the brown wire to the drivers side.

After all that work I still don’t know why the lights won’t come on. Everything else works perfect.

Shoot. That’s frustrating. It’s been a while since I installed those, so I don’t think I’m going to be much help. Is there anything I can check on mine that might help you out?

 

[Jmitchelltfo]

Shoot. That’s frustrating. It’s been a while since I installed those, so I don’t think I’m going to be much help. Is there anything I can check on mine that might help you out?

I will call there RC today and try to get an answer. I’m not the only person that has had a light issue according to what I’ve read.

 

[Lone Wolf 70]

Was able to put a couple switches, inline, of the factory wiring.

I wanted to do the same...How did you splice them in?

Sponsored