Rokblokz install help

[SpaceWhiteF150]

It’s the quietest F150 I’ve ever been in, coming from my 2018. Then again I’ve never been in another gen14, so maybe they’re all quieter than the previous gen.

That would be the only reason to switch from plastic to carpet that I could think of

Sponsored

 

[Zyvin]

I’ve never had plastic front liners on a F150; 2009, ‘11, ‘13, ‘14, ‘18, ‘21.

 

[t5brick]

The liners in the Rokblokz install video actually look similar to mine.

I just don’t have the dang screw where I need one. ?

 

[SpaceWhiteF150]

The liners in the Rokblokz install video actually look similar to mine.

I just don’t have the dang screw where I need one. ?

My fronts are plastic!

 

[mxwrk]

I have the same mud flaps and the same felt liners. Ill take a look when I can and let you know. Side note...after I removed the felt board "skid plate" and put on a steel RCI skid plate, there was a fairly noticeable but not bothersome noise level change. So that felt stuff really does help with road and engine noise

 

[Karytas80]

Mine is 23 XLT 302a and I have the same felt liner in the front. I installed my Rokblokz mud flaps without any issues about a year ago.
So are you saying, you don't have a screw in the same spot showing in the picture below?

This is from their installation video, and the below is picture I took this morning:
(sorry it is a really bad quality picture)

 

[t5brick]

So are you saying, you don't have a screw in the same spot showing in the picture below?

thanks for the picture. And that is correct. I don’t have a screw or screw hole in the felt liner in the location shown in the images. There is a tab from the fender with a hole in it(picture in OP), so I’m guessing that is where the hole in the felt and the screw SHOULD be.

 

[mdn14]

You should be able to line up that long, skinny, plastic behind-the-mudflap bracket to see if you need a hole there. If you do, just drill away. It doesn't have to me marked and aligned perfectly.

I had to drill a hole in my rear husky liners but those weren't a factory option so drilling the hole was more obvious.

 

[t5brick]

Rokblokz support got back to me and they’re sending me a few extra pieces. They listed screws and some clips for the liner. Once they arrive, I’ll take some pictures of the install and post them up here.

 

[Aliass24]

Rokblokz support got back to me and they’re sending me a few extra pieces. They listed screws and some clips for the liner. Once they arrive, I’ll take some pictures of the install and post them up here.

Did you get these installed and what did you end up doing?

 

[t5brick]

Did you get these installed and what did you end up doing?

The first set of hardware they sent me included a set of screws and clips that didn’t work together. The screws were too small for the clips.

They sent me a second set of hardware, this time with screws and clips that actually threaded together.

The weather hasn’t been great lately and I’ve been busy with work or family stuff most weekdays so I hasn’t spent much more time on it. Might take another swing at it today though!

Sponsored