yuba
Member
- Thread starter
- #1
I've got a 2024 2.7 and the brake pedal is super sensitive on initial application, this is pretty annoying to me when switching between vehicles - especially since I mostly use it to tow a race car and swap between the two right away.
The truck is bone stock and it is my understanding that these trucks are brake by wire or at least the brake boost is controlled electronically rather than by vacuum. Is there some kind of coding that is used in a different trim package that slightly reduces the assist or softens the start of the brake pressure curve?
I haven't found much searching around the internet so I figured it was worth asking.
The truck is bone stock and it is my understanding that these trucks are brake by wire or at least the brake boost is controlled electronically rather than by vacuum. Is there some kind of coding that is used in a different trim package that slightly reduces the assist or softens the start of the brake pressure curve?
I haven't found much searching around the internet so I figured it was worth asking.
Sponsored
Last edited: