3D Printed Tweeter Mount for B/O A-Pillar

[nickn066]

I created a mount for the non-B/O A-Pillar and had some request for the B/O style, so I bought an A-Pillar to model it up.

Sponsored

 

[GDN]

Great job and I know it will be useful to some, but not sure why if someone has the B&O system and they are upgrading why they don't just take the factory tweeter out of the factory housing - and put the new tweeter in?

 

[nickn066]

Easier to go back to stock since you aren’t cutting or modifying factory parts.

 

[Ham]

I created a mount for the non-B/O A-Pillar and had some request for the B/O style, so I bought an A-Pillar to model it up.

@nickn066 Should there be a left and right file? I'm not familiar with 3D printing so I don't know if there's a flip/mirror image function that is done. Looking at the file I only see one mount. I'm asking because I have a buddy that will print this out for me but I need to know if there's any special instructions to print the "pair". Thanks.

 

[nickn066]

@nickn066 Should there be a left and right file? I'm not familiar with 3D printing so I don't know if there's a flip/mirror image function that is done. Looking at the file I only see one mount. I'm asking because I have a buddy that will print this out for me but I need to know if there's any special instructions to print the "pair". Thanks.

You have to mirror the print.

 

[Ham]

Got it, thanks

 

[Ham]

You have to mirror the print.

Used these to install some SI tweeters. The left side lined up perfect. The right side needed some working to make the mount points lineup. I had someone do the printing for me so maybe the mirroring or whatever didn't correlate exactly on his system or maybe the 2025 is a little different. It was close enough to get it to work so huge thanks for this. Made for an easier solution.

Sponsored