22 Tremor BCM programming

[Cranberry66]

Hey everyone, not sure if this is the right section for this but looking to see if anyone has some insight on a bcm programming I’m doing for a 22 tremor. The BCM is New from the dealer, I am using FdRs for th BCm PMI procedure, and I also have nastf credentials. However, when doing the PMI process it boots itself out. Tried doing a BCM configuration but it won’t work unless the PMI is done. I went into Forscan and inputted the BCM build data but when I go to write it it fails after block 34. I tried to go into the gateway module and run the TRON function but it also fails and I get an error NRC 31. So with that being said I’m not sure where to go from here I feel like I’ve tried everything, and I have a used bcm in route to see if I can configure that and then be able
To do the pats parameter reset in the PCM. Truck doesn’t start until all that’s done. So any insight would be greatly appreciated

Sponsored

 

[Jesse-Infotainment]

TRon doesnt exist for 22

What is the BCM part number.

Did you program the keys? The first thing that you do when a new bcm is installed is program the two keys. Then you go back and run the PMI.

 

[Cranberry66]

TRon doesnt exist for 22

What is the BCM part number.

Did you program the keys? The first thing that you do when a new bcm is installed is program the two keys. Then you go back and run the PMI.

good to know tron doesn’t exist for it. I was just trying to everything at that point. But yes I did program 2 keys to it. I even tried to program the bcm as a police unit and it gets further in the process but at a certain point after it is at the BMS part it fails

 

[Jesse-Infotainment]

Well if you want I can remote in and get it done..

Can you also confirm the part number

 

[Cranberry66]

I’ll confirm the part number tomorrow. I believe it’s the same part number since it was ordered by vin. And as far as the remote in I wouldn’t mind however I want to try a few other things first because I’m the type that just tries to figure things out without giving up

 

[HammaMan]

I’ll confirm the part number tomorrow. I believe it’s the same part number since it was ordered by vin. And as far as the remote in I wouldn’t mind however I want to try a few other things first because I’m the type that just tries to figure things out without giving up

You can figure it out by watching him do it. Jesse solves things dealers can't get past.

 

[Ivanberr2003]

Hey everyone, not sure if this is the right section for this but looking to see if anyone has some insight on a bcm programming I’m doing for a 22 tremor. The BCM is New from the dealer, I am using FdRs for th BCm PMI procedure, and I also have nastf credentials. However, when doing the PMI process it boots itself out. Tried doing a BCM configuration but it won’t work unless the PMI is done. I went into Forscan and inputted the BCM build data but when I go to write it it fails after block 34. I tried to go into the gateway module and run the TRON function but it also fails and I get an error NRC 31. So with that being said I’m not sure where to go from here I feel like I’ve tried everything, and I have a used bcm in route to see if I can configure that and then be able
To do the pats parameter reset in the PCM. Truck doesn’t start until all that’s done. So any insight would be greatly appreciated

Question, how did you get nasft credentials?

 

[Cranberry66]

Question, how did you get nasft credentials?

Gotta just follow the nastf guidelines on how to be approved for nastf.

Sponsored