Yessir. Checked theChecked IPMA and APIM?
| IPMA | 706-02-02 |
| APIM | 7D0-01-01 |
| APIM | 7D0-01-04 |
Sorry...meant "write" not "save"
Well I think your truck hates ya then, have a chat with it.Thank you! Found that menu and conducted the reboot of both modules. Just checked and all values are still correct!
| Enable Cameras at Speed | IPMA | 706-02-02 | xxx* **xx xx-- |
| Enable Cameras at Speed | APIM | 7D0-01-01 | xxxx xxxx **-- |
| Enable Off Road Views at Speed | APIM | 7D0-01-04 | xxxx **xx xx-- |
| Enable 50-50 views | APIM | 7D0-01-01 | xxxx *xxx xx-- |
| Enable 50-50 views at speed | APIM | 7D0-01-04 | xxxx xxxx x*-- |
| Removes black box on reverse camera that says "full view not available" - APIM Reset May Be Required | APIM | 7D0-02-02 | xxx* xxxx xx-- |
| Enable OffRoad (Rock Crawl, Mud/Ruts, and Deep Snow/Sand) Front Camera at Speed | IPMA | 706-02-02 | xxxx xx** xx-- |
| Enable 50-50 views at speed | IPMA | 706-01-02 | *xxx xxxx xx-- |
@SilverPigeon, I typed in my values into your lines (above). I was successful in removing the black box using Livnitup's Forscan Google Sheet but I only stuck with the options in the Common tab. Thank you.@filasb In fact, please show what values you have for any of these features that you use:
?
Enable Cameras at Speed IPMA 706-02-02 xxxF CExx xx-- Enable Cameras at Speed APIM 7D0-01-01 xxxx xxxx FD-- Enable Off Road Views at Speed APIM 7D0-01-04 xxxx FDxx xx-- Enable 50-50 views APIM 7D0-01-01 xxxx 0xxx xx-- Enable 50-50 views at speed APIM 7D0-01-04 xxxx xxxx x0-- Removes black box on reverse camera that says "full view not available" - APIM Reset May Be Required APIM 7D0-02-02 xxx5 xxxx xx-- Enable OffRoad (Rock Crawl, Mud/Ruts, and Deep Snow/Sand) Front Camera at Speed IPMA 706-02-02 xxxx xx03 xx-- Enable 50-50 views at speed IPMA 706-01-02 3xxx xxxx xx--
NoAnyone know if it’s possible to add the trans and engine temps to the 8” cluster?
1. Do you have the 12" cluster? I assume so.Got a new 24 to night and was messing around trying to add digital Temp to trans and engine. but when i changes the as built in the ipc only the engine temp worked, not the trans temp. any ideas on why this didn't work.
![]()
1. Do you have the 12" cluster? I assume so.
2. Do you have the Trailer Brake Controller?
3. What value did you use?
i have the 12inch ipc with trailer brake. I used E5.. I did notice that my dash has the oil temp gauge next to oil pressure... i guess that's why i don't see a trans temp. any way to replace the oil temp with trans temp... i ran throw the setting but don't see anything to switch them. if i go into my view. then gauges i can see all temps...1. Do you have the 12" cluster? I assume so.
2. Do you have the Trailer Brake Controller?
3. What value did you use?