2021+ F-150 FORScan List / Database / Spreadsheet

[ahmedaalagha]

Halogen the brake and turn are parking lamps. I do see looking at spreadsheet there is nothing that calls out parking/running lights specifically. It could be rolled into the brake and turn signal outage.

Outage for turn are disabled but the lught still shuts off, i will look for another solution then!

Sponsored

 

[CND Supercrew]

Is this laptop good enough to run Forscan now and in the future??

 

[svtzx2]

Is this laptop good enough to run Forscan now and in the future??

Yes, ForScan doesn't need a ton of resources.

 

[HammaMan]

Outage for turn are disabled but the lught still shuts off, i will look for another solution then!

Not saying these values are for you but your answer is likely within

 

[ZKeith]

Anyone have values for speedometer recalibrations for 35/12.5 R18 that won’t set a code for implausible data received?

 

[Nightshade]

Has anyone with a 24 model disabled the loud beeps in the interior when you exit the truck with the key while it’s running?

I sure miss phone as a key!! Ford should have this standard on higher trim levels.

I haven't gotten around to trying it out with my 24 but try the following; not 100% sure if its for physical key or push to start but backup your module before you write it; report back to confirm if it's working:

Disable key-in ignition chime

IPC

720-02-01

xx*x

xxxx

xx--

subtract 8 from current value (if E change to 6)

 

[Beaux]

I haven't gotten around to trying it out with my 24 but try the following; not 100% sure if its for physical key or push to start but backup your module before you write it; report back to confirm if it's working:

Disable key-in ignition chime

IPC

720-02-01

xx*x

xxxx

xx--

subtract 8 from current value (if E change to 6)

I’ll try it again but if this is the same out of the spreadsheet then it didn’t work. I tried it over the weekend. Thank you!

 

[SilverPigeon]

Has anyone with a 24 model disabled the loud beeps in the interior when you exit the truck with the key while it’s running?...

Just to verify: have you disabled the double-honk when leaving cabin with engine running?

 

[Beaux]

Just to verify: have you disabled the double-honk when leaving cabin with engine running?

yes. That is a factory setting now and FORScan isn’t needed.

 

[fordtruckman2003]

yes. That is a factory setting now and FORScan isn’t needed.

Seriously?
That is great.

 

[Nightshade]

I’ll try it again but if this is the same out of the spreadsheet then it didn’t work. I tried it over the weekend. Thank you!

Sounds good, report back when you do! Just got around to disabling the key-in chime and door ajar (both on the spreadsheet), can confirm it's disabled on my 2024 Ford F-150 Lariat!

 

[Beaux]

Sounds good, report back when you do! Just got around to disabling the key-in chime and door ajar (both on the spreadsheet), can confirm it's disabled on my 2024 Ford F-150 Lariat!

The door ajar works but I still can’t get rid of the chime for key not detected when I get out and leave the truck running.

 

[Nightshade]

The door ajar works but I still can’t get rid of the chime for key not detected when I get out and leave the truck running.

Do you recall what your original value was for the "*", in line 720-02-01 (IPC) in xxxx-xx*x-xxxx?

 

[Beaux]

Do you recall what your original value was for the "*", in line 720-02-01 (IPC) in xxxx-xx*x-xxxx?

E

 

[Nightshade]

E

Okay, try this again. Restore that IPC module to the backup you made before you wrote the values just to rule it out (hopefully you backed up the module before you made the change). Then make the changes as following and write to truck. Cycle off/on and it should work:

720-02-01 (IPC) in xxxx-xxEx-xxxx -> 720-02-01 (IPC) in xxxx-xx6x-xxxx

​

**Another way, if this doesn't work--go to IPC (non-asbuilt /easy way) and search for "chime", see if "key ignition" or similar shows up and changed from "enabled" to "disabled".

Sponsored