This looks sweet. How'd you get this done? It would add an extra touch if those letters lid up, but I'm guessing that would require an entire new plate. ;/Wrapped the rear applique with carbon fiber. It's one of the first large pieces I've tried. A few minor flaws but hardly noticeable.
ohhh yes a JODY joke ..love itAdded a sticker
It's hardwired. I had a guy on here make me a harness that tee'd off the lower glove box light up to the upper glove box. Instead of going with the OEM white glove box light, I used the blue media bin light. Both are physically the same size so it just clicks right into the opening in the lower glove box. I like the way the blue looks better so I went with that. I did have to cut the opening in the upper glove box which was the hardest part, but I first made a template and marked where I wanted it and then used a Dremel to cut it out. Something to note is that the white glove box light has a female connector and the blue media bin light has a male connector so I had to have the harness made for that application.
That is a great idea. I bet you could still T off it and add all 3. I might do that
Add all 3? Do you mean the upper and lower glove box and media bin lights? If so that's actually what I did. Surprisingly I already had the factory media bin connection so I had him make me a harness to tee off the media bin light and run up to the glove box light. The issue was that the harness had a male connector on the end since I was initially going to go with the OEM white light which has a female connector. When I decided to go with blue media bin lights I had to have a new harness made with female connectors on both ends and another female connector in the middle. In hindsight I would have had him just make me a harness from the media bin light up to the glove box area with two female connectors. In the end it all worked out.That is a great idea. I bet you could still T off it and add all 3. I might do that
