jtothemak
Member
- Thread starter
- #1
I'm using an LC1i and 1600watt Amp to power two kicker CompVT 10 inch Subs downfiring under the truck's back seat in a sealed box. 23 F150 with 8 speaker B&O. Stereo eq set to middle. I get it. I should be using the LC2iPro or Kicker Lockkey and will probably upgrade, but this is my setup currently. Am I doing this all correctly for the setup I currently have?
1. LC1i—The input is coming off the wire to the stock sub. With the stock stereo up 3/4 way and the test tone -5 40hz, gain all the way down on sub amp adjust the output of the LC1i should be 5v, and there should be no max light. The amp is rated up to 5v input.
2. Amp Setting -
Phase 0-180 - at 0
LPF Dial 50-250hz -100Hz or 80Hz?
Bass Boost Dial 0-15db, set to 0?
Bass Boost Freq Dial 40Hz to 100Hz does not matter if bass boost is at 0?
Subsonic Dial 10-50hz - 20hz?
3. Amp Gain: Kicker CompVT 2ohm subs have 350RMS. So, sqrt of 350*2 is 26.45 volts, but since I have two subs in parallel, should that be 52.9 volts?
1. LC1i—The input is coming off the wire to the stock sub. With the stock stereo up 3/4 way and the test tone -5 40hz, gain all the way down on sub amp adjust the output of the LC1i should be 5v, and there should be no max light. The amp is rated up to 5v input.
2. Amp Setting -
Phase 0-180 - at 0
LPF Dial 50-250hz -100Hz or 80Hz?
Bass Boost Dial 0-15db, set to 0?
Bass Boost Freq Dial 40Hz to 100Hz does not matter if bass boost is at 0?
Subsonic Dial 10-50hz - 20hz?
3. Amp Gain: Kicker CompVT 2ohm subs have 350RMS. So, sqrt of 350*2 is 26.45 volts, but since I have two subs in parallel, should that be 52.9 volts?
Sponsored
