Jump seat to console -- DTC help please

[Onyx]

There could be other dependent variables in another module, it could also be that they do some strange wiring config that's dependent on that being connected as a jumper. I don't have time to dig into but I do know there's been several conversions done. Might be able to pull a similar truck's asbuilt and start comparing them to find deltas.

SUCCESS!! Thanks for your help. I found a VIN of the exact same truck but with the console and plugged it into https://www.motorcraftservice.com/AsBuilt

Going through RCM and IPC again I found a mismatch at:

720-02-02 xx** xx--
RBM Seating Layout (Running Board Module?)

Mine was set to RBM 3-3-3 and the truck with the console was set to RBM 2-3-0. Made the change and dash warning disappeared ? Now I can sell the jump seat with the seatbelt sensor in tact.

Sponsored

 

[tuononero]

What were the values you changed exactly? I am trying to do the same mod to a 2023 F450 standard cab and the stupid IPC shows me a picture of the three front seats with the middle one in yellow with a question mark.

 

[HammaMan]

What were the values you changed exactly? I am trying to do the same mod to a 2023 F450 standard cab and the stupid IPC shows me a picture of the three front seats with the middle one in yellow with a question mark.

Go through the seating configs in the spreadsheet. There's more than one section that deals with it.

 

[tuononero]

Oh wow I discovered a world.

Would you be able to give me an idea what R and C are?
Like I see R2C5. What does that refer to?

And which one would the jump seat be?

Sponsored