How do I adjust the threshold of front sensor triggering 360 camera by ForScan

[ylin822]

Right now when parking to the front. The front sensor only beeps and triggers 360 cameras when my truck is few inches to the front object. Is there a way to adjust that to make it like 4ft?

Sponsored

 

[SilverPigeon]

You can try the following configuration changes but there WILL be consequences:

706-22-01	****	****	xx--	SensorCfg_DPAC_FrontFocalLength (SCDPACFFL) • Millimeters = Hex2Dec(********)
706-22-02	xxxx	xx**	**--	SensorCfg_DPAC_LeftFocalLength (SCDPACLFL) • Millimeters = Hex2Dec(********)
706-22-03	****	xxxx	xx--	SensorCfg_DPAC_LeftFocalLength (SCDPACLFL) • Millimeters = Hex2Dec(********)
706-22-03	xxxx	****	**--	SensorCfg_DPAC_RightFocalLength (SCDPACRFL) • Millimeters = Hex2Dec(********)
706-22-04	**--			SensorCfg_DPAC_RightFocalLength (SCDPACRFL) • Millimeters = Hex2Dec(********)

Among other potential problems, you could have:
1. Park warnings always showing yellow and red way before they used to.
2. If you have APA, it may crash you into something If you try to use it.
3. Parking sensor alignment may be bad, requiring a service procedure to run.

I would NOT fool with those configuration values.

 

[ylin822]

You can try the following configuration changes but there WILL be consequences:

706-22-01	****	****	xx--	SensorCfg_DPAC_FrontFocalLength (SCDPACFFL) • Millimeters = Hex2Dec(********)
706-22-02	xxxx	xx**	**--	SensorCfg_DPAC_LeftFocalLength (SCDPACLFL) • Millimeters = Hex2Dec(********)
706-22-03	****	xxxx	xx--	SensorCfg_DPAC_LeftFocalLength (SCDPACLFL) • Millimeters = Hex2Dec(********)
706-22-03	xxxx	****	**--	SensorCfg_DPAC_RightFocalLength (SCDPACRFL) • Millimeters = Hex2Dec(********)
706-22-04	**--			SensorCfg_DPAC_RightFocalLength (SCDPACRFL) • Millimeters = Hex2Dec(********)

Among other potential problems, you could have:
1. Park warnings always showing yellow and red way before they used to.
2. If you have APA, it may crash you into something If you try to use it.
3. Parking sensor alignment may be bad, requiring a service procedure to run.

I would NOT fool with those configuration values.

Thank you for the response! Is there Any config code on 360 cam or what triggers 360 cam.

 

[SilverPigeon]

Not to my knowledge. Passing the focal length threshold would tell the IPMA to display 360 view on the APIM, probably a fixed function in hardware/firmware/software.

Sponsored