Can I change the delay time in the auto high beams using forscan?

[CBAlsum]

I've been looking through the Livnitup's Forscan spreadsheet but I haven't found anything that might allow me to change the delay time for when a car passes and the high beams come back on. I know I can just flick the high beams on manually but the auto high beams are pretty sweet i just think the 5 second (guessing here) delay is a little much

Sponsored

 

[powerboatr]

not sure if it is a delay
the camera up on the windshield is used to sense light from on coming vehicles, not time.
IIRC

 

[CBAlsum]

not sure if it is a delay
the camera up on the windshield is used to sense light from on coming vehicles, not time.
IIRC

its pitch black out. not even road side reflectors. but it take a few seconds to react. might just have to live with it

 

[RcFlyer330]

Thats kinda interesting because I would like a longer delay for the high beam to come back on after a car passes. there have been many times where the vehicle spacing, hills, or curves where one car will pass and I end up flashing the next vehicle. For example a vehicle will dip below a hill and I end up flashing them. I also have one spot in my drive with a over head road light that will trigger high beams off and on multiple times within 20 seconds. I am 50/50 on liking or hating outo high beams.

Sponsored