Build Error New 2025, XL, RCSB

[Larrymoe]

Yet another reason why I'm glad I held out for a 101a...

Meh. I'd rather have an extra inch of plastic to have to live with than shit wheels and painted bumpers. To each their own.

Sponsored

 

[TopOMichXL]

I’m not wild about the work surface, but it doesn’t bother me. There’s a little bit of extra storage underneath.
I like the darker bumpers that come with 101A, I’m not much of a fan of the steel wheels and I wanted the chrome bumpers for corrosion resistance.
I’ve seen 13th gen Sport trucks with pretty nasty bumpers.
And the fog lights are nice.

 

[5.0 Junkie]

Pull passenger seat, then undo two wiring connectors on console. Pull side console bolts on pass side. On drivers side long extension and just move seat up and back to access. Pull console out. Black plastic pieces covering hinge area are clamshelled together. Slowly work them apart with a thin screwdriver. The pass side clamshell is almost tethered with a vinyl strap that covers the hinge. I left mine attached and just used it when I swapped them.

Top pick is pass side. Bolts go from the inside. Bottom pic is driver side. Bolts thread in through the outside. Undo work surface sensor connector at the base of the console. A few clips holding wire if I remember right. When you pull the 4 bolts out, the entire upper half of the jumpseat comes off. Do the same thing to the other jumpseat and swap the tops. Put bolts back in and clip black trim pieces back together. Put it all back in truck.

Sponsored