B14E7 08 0A BCM code, help needed

[steveoeg6]

Hey guys, continuation from a different thread, but thought I’d put it here also for viability..

Backstory: 2021 screw xlt powerboost, did a quad led to projector led swap. I am needing to revert it back to stock. Put the stock headlight in and everything works except the high beams.

DTC code is B14E7 08 0A bus signal/message failure.
Same issue with the other side, B14E5.

to my knowledge all of the forscan revert changes were good, and even tried doing the BCM LIN initialization through mongoose, but cannot get these codes to clear. Anyone have any insight to what may be the solution? Any help would be greatly appreciated!

Sponsored

 

[steveoeg6]

Bump for some eyeballs

 

[HammaMan]

look in your forscan directories to see if you/it saved your original asbuilt and revert. One saves the entire thing as the VIN for a file name whereas you should have saved it before making the changes.

 

[steveoeg6]

Forscan updates are solid, I’m thinking this is more a communication issuse or a module recognition thing

 

[HammaMan]

Forscan updates are solid, I’m thinking this is more a communication issuse or a module recognition thing

Nah, when you go into forscan make sure you're not accessing the saved profile. I'm thinking PEBCAK at this point

Sponsored