Glare free not working: 302a XLT upgraded to Projectors w/ HCM

[ProperRCLB]

This is the VIN that is currently in that HCM 1FTFW5L80SKD28128

Not my VIN. Will update and report back.

Sponsored

 

[ProperRCLB]

VIN updated still same error on the dash and no high beams or glare free.

I have a SCCM DTCs due to a wrong switch. I'm going to fix that and swap out the switch to see if that could be the culprit.

 

[PFXLT]

VIN updated still same error on the dash and no high beams or glare free.

I have a SCCM DTCs due to a wrong switch. I'm going to fix that and swap out the switch to see if that could be the culprit.

You didn’t make any other forscan changes when adding the level sensors? Is your high beam switch set to auto and have you tried pushing the turn signal stall forward to “reactivate” auto high beams to get your green A back?

 

[ProperRCLB]

You didn’t make any other forscan changes when adding the level sensors? Is your high beam switch set to auto and have you tried pushing the turn signal stall forward to “reactivate” auto high beams to get your green A back?

Correct I made all the changes shown on the Forscan changes sheet.

The only one that is not allowing me to make is the one on the HCM on 734-01-02 and 734-01-01 saying that changes are not compatible.

My high beams don’t work at all. Which is why I believe this has to do with something else.

 

[PFXLT]

Correct I made all the changes shown on the Forscan changes sheet.

The only one that is not allowing me to make is the one on the HCM on 734-01-02 and 734-01-01 saying that changes are not compatible.

My high beams don’t work at all. Which is why I believe this has to do with something else.

Do they dance on startup?

 

[ProperRCLB]

Do they dance on startup?

Blue light turns on in dash but no high beam
No dance on startup
Dash error “Adaptive Light” malfunction

 

[antho]

Can you post your SCCM asbuilt?

 

[ProperRCLB]

Can you post your SCCM asbuilt?

Here is my SCCM:

I managed to get high beams to work. Pin 6 needed to be swapped with pin 5 on the 16-pin headlight connector from Ryan's harness.

HCM is still giving issue not allowing me to change the 734-01-01 or 734-02-01. Saying "Configuration incompatible and still displaying the "Adaptive Front Headlight system temporarily unavailable."

Here is my HCM configuration:

HCM DTCs.

Sponsored