Recent content by PW2150

Has anyone seen or heard of a hp tuners unlocked truck having problems with the OTA updates? thanks PW

Preventing a cat failure was my thoughts as well. went with a set of spd 3” pipes that go from the stock manifolds to a gen 3 raptor exhaust. I kept the big ass resonator and ditched the raptor muffler for a dual 3” in dual 3” out magnaflow. It is a true dual set up. Almost too quiet. I have...

I am running Gesi UHOs on a set of spd pipes. What information are you looking for? PW

Thanks for the response. PW

Looking for the part number for the brake line that runs from the driver rear side over the rear differential and ends at the passenger side rear brake caliper. after I lowered the rear of my truck, on hard throttle my exhaust was rubbing on the line at the differential, and I need to replace...

Sorry just realized I missed spoke, gen 5 stage 2 whipple Phillip

I have a set of SPD pipes on my 2021 that bolt up to a gen 2 raptor cat back exhaust. I went this route after installing a gen 2 whipple. Ended up ditching the raptor muffler for a huge 3” dual in dual out magnaflow. Pipes are ran to the rear passenger side. They down pipes fit great and the...

WOW!!!

3.73 here, all launches were in 4high.

Post!!! Stage 2 whipple , bone stock running 93 pump gas

My screw went 5.3s pretty consistently pre whipple here is a 0-60 on the dragy when bone stock Phillip

Great looking truck! I am not seeing a part number for the Laminx 3Rd brake light and side mirror markers. Do they offer pre cut or did you make them from a blank piece? thanks Phillip

Yeah, sport mode TC off , 4h and it seems to do better if I hold the brake, floor it , and launch as the rpm’s climb close to the stall. Maybe a fluke but this method was consistently quicker than holding the brake and gas a few seconds and launching it. PW

That run was bone stock on e85 PW

My Screw 4x4 did 13.73 @ 99 mph last winter. It is not the lightest truck (loaded 302a with sunroof).