Recent content by pelon222

Also very interested, been thinking about it for a while now. Would it be possible to share the part numbers please, I was able to get the 2 showing but if you have wiring harness, motor and actuators. Also programming if it’s not too much to ask

I wouldn’t say that’s normal..

There is a thread with all the instructions for this retrofit

https://www.f150gen14.com/forum/threads/how-to-install-factory-360-camera-system.18046/ hope this helps

There I s a good thread with a lot of info on the retrofit

Is possible you might have fried something. Why not just get a 12” APIM you can find them on eBay 2-3 hundred

You probably need to repin the camera on the new harness. I had to do that on my XL as I upgraded to LED tails. In my case it was the camera and the lock.

I was programming a console shifter for a friend Monday and used FDDRs to see if I had updates pending, few modules showed up but didn’t have the time to update them. Maybe I can use your help with my IPC, I’ll send you a PM

I just got this update, so was this just an APIM update or was there other modules updated as well?

You could either check for voltage or your grounds to make sure it’s not a BCM issue or a connection issue

Most people who know won’t tell you part numbers specially if they’re making money off of them. Best think to do is looking at the connectors and see if there are part numbers printed on them. The you can do more research and find mating connectors and pin part numbers

Keep us updated, that’s what I want to do next on mine, just haven’t had a chance. I need the part number as well

I did the same thing, I had to remove the wires from my old harness and added them to my new harness, same thing with the Camera, I had to repin it as well based on my old configuration.

Ok, signal out the IPMA into the APIM. I was thinking IPMA had to be bypassed Thanks for clearing it up

I’m still confused on how you get the signal from the camera to connect to the APIM