Recent content by JMoney17$

I am going to try an eco-worthy battery first and see how that works out. When I look at the voltage monitor attached to my main AGM battery it says 100% charge. The vehicle battery state of charge in the OBD MX tool is 86%. Additionally when I put in the new battery and reset the BMS system...

My voltage just steadily trends down every day. The LFP battery provides a brief rise in resting voltage but it drops back down over a week. I am wondering if I have some other parasitic drain. I have a usb voltage monitor for the battery and the mega ohm device to turn off the EV sounds but...

I have the battery monitor and the OBD MX+ hooked up. That is it. There shouldn't be any other devices.

So I went and replaced every battery and made sure everything was fully charged. I reset the BMS. Voltage initially popped up to 13.2V at rest but has continually trended down. I did about a 4 hour drive this weekend and it does not appear to have changed the downward trajectory. I usually do...

I think I am just going to replace my main 12V battery. I have been monitoring the voltage with the truck at rest parked. With the lithium battery it goes from 13.2V down to 12.7 volts over the course of 3 days. These graphs demonstrate 2 cycles of using the lithium battery with rapid draw down.

This is the Data I was able to pull tonight. Again I fully charged the main 12v battery and installed/charged a larger AUX battery about 2 weeks ago. I fully charged the lithium battery Sunday and reinstalled it. I have previously set forscan to maintain a charge of 100%. I don't know why my...

I found them I think. Thanks!

@Jmitchelltfo I can't seem to find those dashboard monitors in the MX system? Do you know where they are? I tried downloading snakebitten's dashboards but they don't seem to be working correctly for me using an iPhone.

@Jmitchelltfo I have an MX+ but I was not running the data fields you are showing. I just downloaded the @Snakebitten files for the MX+ so I will give it a try tomorrow and see what they are showing. I monitored the voltage today and it dropped from 13.2 to 13.1. Thanks for the...

I was having low battery for awhile I believe and then got the 12 volt warning in the app which led me to take action. I had previously replaced the original battery shortly after purchasing my '23 powerboats with an H7 battery. It is probably 2-2.5 years old. After the warning I replaced the...

I haven't installed it yet. I found a video online where a guy mounted his box over the fuse box near the passenger side (Different up fitter switch unit). That is the only area that I think you can put it unless you lengthen the wires. I printed out a wedge I can use above the fuse box at an...

I have a Mongoose plus which I believe should be adequate but I have not used it yet. I have pretty much stuck to Forscan.

I went in Forscan and made the changes necessary to all the modules but could not get either lariat level HVAc module to turn the heated seats on. I did not see the conversations above until after I posted my recent comment. My question is how do you program the HVAC module to work without a...

I have an XLT with heated seats. I tried 2 different HVAC modules with buttons for heated and cooled seats. I could not get them to turn on the heated seats. I am pretty sure that the heated and cooled seats have their own module in 1 of the seats and thus it is not present in the HVAC module...

Sent you a message with instructions