Recent content by billybob

If I'm not expecting much changes I might just give up for this weekend of updates. How about the APIM? I did it yesterday and thought it was done but since I did that read config a new one showed up.

I didn't see any codes I don't see any and drives fine.

PSCM PMI worked but IPMA did not automatically start after. IPMA fails about 1/3 through configuration still.

OK, I think the PSCM is the issue it's mostly offline. I can see it when running but not with just ignition.

Same issue on IPMA update but I see another APIM update has shown up now.

Done.

"Read the configuration data"?

Another error message after the retry issue. Voltage was above 13 the entire try.

I'm on number 3 for free from ford.

I now have a bigger 20amp supply from kanuck and still has the same issue if I run update or PMI.

I think it might be my Norco is not big enough. I was checking voltage then running it and going inside. Before and after it was 14V but I see it slowly trickle down once it starts.

Nope, ACJ.

Inside the toolbox? I looked through the tabs but did not see where the file names are.

The power steering did show up yesterday and I ran the upgrade fine. I’m not sure why it is grey this morning, would that prevent the IPMA?

I'm down to IPMA, BCM, and ACM which have not been successful yet.