I was not able to edit the configuration to add in bed lamps as part of courtesy lighting. I was, however, able to put courtesy lighting under full manual control of the bed lamp switch, but then the bed lamps don't work
. That can be done by changing the below from 2 to 1.| Ext_Courtesy_Sw_Input_Cfg (ECSIC) | ||||||||
| 726-81-01 | x*xx | xxxx | xx-- | 0 = | ECSIC NULL | 2 = | ECSIC MAN_PUDDLE | |
| 1 = | ECSIC EXT_COURTESYLAMP_SW |
Hahaha dang! Thanks for trying! Iām wondering if I could make a connection from the the courtesy circuit to the bed lamps with an inline resistor to eliminate back feeding when you manually turn on the bed lampsā¦??I was not able to edit the configuration to add in bed lamps as part of courtesy lighting. I was, however, able to put courtesy lighting under full manual control of the bed lamp switch, but then the bed lamps don't work
Ext_Courtesy_Sw_Input_Cfg (ECSIC) 726-81-01 x*xx xxxx xx-- 0 = ECSIC NULL 2 = ECSIC MAN_PUDDLE 1 = ECSIC EXT_COURTESYLAMP_SW
Are you trying to totally nuke the seat belt pop up at start up? If so under IPC and easy changes, for the driver seat position, change it to none/no seat. Only way I've found. You'll get a silent CEL in the ICP for generator mismatch but will live with that for never seeing the seat belt pop up again.Anyone here know if there is another value that needs to be changed on the 2025 Tremor models to disable the seatbelt reminder? I've tried all of the manual methods (3, 4 and 5 fast buckle/unbuckle) in the owners manual with no luck. I've changed my value for 720-01-01 to a zero, as you can see in the screenshot. I've rebooted the IPC using the service procedure, and still no luck shutting it off. It seems like sometimes it's off, and sometimes (mostly) it isn't for some reason.
Any help would be greatly appreciated!
Try this:
| IPC | 720-01-02 | xxxx x2-- |
Federal Motor Vehicle Safety Standards (FMVSS)
Any idea if it changes anything else?
It doesn't.
21-23 & 24+ are two different animals when it comes to the IPC. Same values for the most part yes, but way different. On my 23 I did the usual seat belt disable and never saw it again. Not so much on my 24. When the new SDs came out in 23 with the new IPC this was a big issue/nanny. It always has the IPC pop up every start up even if you have them disabled. Turning the driver seat off is the only way I've found to totally nuke it.
Try these in the DSM. Set the cushion to a low temp and the back to what you want.
I know, but did you try this change? It's not a part of the common changes and worth trying.
Thanks! This seemed to mostly work. It at least disabled it at lower speeds it seems. It still chimes if I go over 13mph, but I always wear a seatbelt, I just wanted it disabled while moving slow, which this did. Much appreciated!
Welcome; I don't believe there's an accessible configuration change that can disable seatbelt warnings at speed.
