Reg cab console swap electrical.

[Wudzrydr]

Is there a Harness available to buy that I can plug into the Connector under the console to get all the USB ports, etc working in my Reg cab?

My truck is a 23 RCSB XLT and console is from a 21 XLT column shift.

Sponsored

 

[Wudzrydr]

The Connector....

 

[2022Bruce_L]

Also interested as PO opted to not power console.

 

[Wes1963]

The Connector....

You should have the other side of that plug under the passenger seat. As far as what pins are populated I couldn’t say.

 

[Wudzrydr]

This is what's under the passenger seat. The black one is for the jumpseat seatbelt. The grey one was plugged into a blank but doesn't fit. I don't know what it's for.

 

[pelon222]

Don’t think any of those are pre wired for single cabs, I would look up the wiring diagrams for the usb ports and try to make my own harness.

 

[CartelJosh]

Anyone figure this out? About to do the swap on my 24 as well and would like the USB to work.

 

[NavyChief]

Yea I only powered my forward USB for now and left the rest until I upgrade the seats. My unit came from a Lariat so has the sliding lid in front which because the non console wiring is short made it tricky to connect and not impede the door sliding properly.

 

[ProperCrab]

I was adding the sliding cover to my console tonight and now I want all my USB's to work.

These 2 plugs appear to be the same, both will plug into the media USB hub, The second harness is factory-installed on my console and runs to the other USBs on the console. So, does anyone know if we are missing an extra harness on single cabs, or could I have a splitter harness made for the others to get power? Does anyone have a wiring diagram for a console truck?

 

[2022Bruce_L]

Also want to know.

 

[Wallick]

Looking for some answers on this too. Seems like nobody wires the console in which seems crazy to me.

 

[Taylorj7x]

I was adding the sliding cover to my console tonight and now I want all my USB's to work.

These 2 plugs appear to be the same, both will plug into the media USB hub, The second harness is factory-installed on my console and runs to the other USBs on the console. So, does anyone know if we are missing an extra harness on single cabs, or could I have a splitter harness made for the others to get power? Does anyone have a wiring diagram for a console truck?

How did you add the sliding cover? I want to do this but dont know how. I found the part # for the cover but i heard theres an upper trim piece that has to be added as well and I cant find the part # for that.

 

[CincoBlanco]

Anyone find out the harness thats needed for the outlets?

Sponsored