Jumpseat to console swap

[BlueBolt]

Hi, I removed the jumpseat out of my 2022 F150 STX Supercab and installing a center console. I have column shift four-wheel-drive, automatic transmission, 2.7 eco-boost. Smaller display 8in. I currently have the console, but I need the following. Ford parts counter no interest in helping.

-the dash bezel I believe the part number is ML3Z15042C74CA.

-need to connect the AC duct to the flow through ducts going to the back near the cupholders. The connector would be right below the dash appears to be about 4 inches long. Not real sure what to do about the existing under carpet ducts.

-I need the electrical harness to connect the rear console 12 V outlet the two USBs and the little Courtesy light above the USBs and the center glove box power outlet.

-Will need the rear consoles rear USB assembly

-I believe there should be a 12 V cigarette lighter type power assembly inside the console box. Need this.

I believe that's all I need. I hope it all works. I would appreciate any insight you may have to this.

Sponsored

 

[2022Bruce_L]

Nice screen name!

This was my old 04

 

[PaulGrun]

Hi, I removed the jumpseat out of my 2022 F150 STX Supercab and installing a center console. I have column shift four-wheel-drive, automatic transmission, 2.7 eco-boost. Smaller display 8in. I currently have the console, but I need the following. Ford parts counter no interest in helping.

-the dash bezel I believe the part number is ML3Z15042C74CA.

-need to connect the AC duct to the flow through ducts going to the back near the cupholders. The connector would be right below the dash appears to be about 4 inches long. Not real sure what to do about the existing under carpet ducts.

-I need the electrical harness to connect the rear console 12 V outlet the two USBs and the little Courtesy light above the USBs and the center glove box power outlet.

-Will need the rear consoles rear USB assembly

-I believe there should be a 12 V cigarette lighter type power assembly inside the console box. Need this.

I believe that's all I need. I hope it all works. I would appreciate any insight you may have to this.

I'm curious how all this workedout for you, and if you have photos and/or further info you could share. Such as where you got the new console and parts, what it cost, elctrical harnesses, step-by-step, and so forth.
I have a '22 XLT 302a with column shifter and jumpseat. Although I've gotten used to the jumpsuit, which is more or less permanently folded down, I have often wondered about swapping for a console.

Sponsored