Eavedesian
New member
- Thread starter
- #1
Well, it started with the clicking from what I thought was the torsion bar that was mentioned in the TSB but that wasn't the case. The torsion block is tight and bar is positioned correctly.
When I hit the button to open Either on fob or dash. It will start to power down and then just drop, is there a way to reset the position as well because the dash shows its opened now as well.
Additionally 2 mentions. The zoom on the backup camera doesn't work consistently and I recently had to block the power tailgate going up or down when I was getting ready to do some towing so I put it manual. This all started when I put it back in power mode.
Asli am I supposed to put a twist on the torsion bar on the driver's side before I place the tailgate back in?
When I hit the button to open Either on fob or dash. It will start to power down and then just drop, is there a way to reset the position as well because the dash shows its opened now as well.
Additionally 2 mentions. The zoom on the backup camera doesn't work consistently and I recently had to block the power tailgate going up or down when I was getting ready to do some towing so I put it manual. This all started when I put it back in power mode.
Asli am I supposed to put a twist on the torsion bar on the driver's side before I place the tailgate back in?
Sponsored
