2024 Ford F150 PSCM Programing with Forscan

[hchavarria]

I just replaced the Gear rack and pinion and forgot to backup the old PSCM. I tried to reprogram with forscan, but the code still there and it shows a message "Steering assist fault service required". it shows for codes on the PSCM.
U2100:00-6D Initial configuration not complete
U0447:29-6C Invalid data received from Serial data Gateway Module 'A'
U211B:81-2C Control module message authentication /Invalid serial data received
U211B:87-6D Control module message authentication / Missing Message

I download the module built data, but did not work.. any help will be much appreciated.

Sponsored

 

[HammaMan]

Need FDRS to PMI it
Might require TRON auth too

 

[hchavarria]

Need FDRS to PMI it
Might require TRON auth too

Thanks a lot, so I have not choice to get with someone that have FDRS, i can see 2 day license for $50, but need special connector correct?

 

[HammaMan]

Find someone local for a cable assuming that's TX.

 

[hchavarria]

Find someone local for a cable assuming that's TX.

yes I am in Houston TX. I found someone locally that can program for $200. I guess cable cost more than that!

 

[HammaMan]

It'd be cheaper to go buy 30 minutes of shop time from the dealer. If it drives, just go to a dealer and tell them you want the PSCM PMI'd and if required GWM Tron repair tool if run. Takes 15-20 minutes in total.

 

[JohnTrigger]

yes I am in Houston TX. I found someone locally that can program for $200. I guess cable cost more than that!

The cable to use with FDRS is called a Mongoose-plus by Opus-IVS for Ford. $575 on Amazon.

 

[hchavarria]

yes I am in Houston TX. I found someone locally that can program for $200. I guess cable cost more than that!

Does it make a different if is aligned before programing the model or needs to be after? thoughts?

 

[hchavarria]

The cable to use with FDRS is called a Mongoose-plus by Opus-IVS for Ford. $575 on Amazon.

thoughts about this one? TOPDON RLink J2534

 

[hchavarria]

It'd be cheaper to go buy 30 minutes of shop time from the dealer. If it drives, just go to a dealer and tell them you want the PSCM PMI'd and if required GWM Tron repair tool if run. Takes 15-20 minutes in total.

how much do you think the dealer normally charge for ~30min

 

[HammaMan]

thoughts about this one? TOPDON RLink J2534

Garbage

 

[JohnTrigger]

I don’t think there is any other suitable cable, lesser priced than the mongoose. I think nearly everyone on here will agree. Other cables have a high probability of bricking your system and then you need to spend thousands to replace it.

 

[hchavarria]

Make sense. The alignment is off after replacing the rack and pinion… should I get the alignment first and then program de module? Or doesn’t matter the order? Thoughts

 

[hchavarria]

Found a cable, ready to purchase 2 days license. Does the battery require to be connected to a power supply or not necessary? Thoughts

Sponsored