2021 ford f150 xlt 302a package

[hcrouch0092]

I’m having an issue with my cruise and 360 cams. When going into the ipma module configuration and studying. I am seeing a lot of things that should be on turned off or disabled. Would someone like to do me a solid and send me their IPMA module configuration for a truck with similar features?
Trying to see if maybe there might be any issues there before starting to replace parts. I sadly don’t have access to FDRS or the adapter to check for updates

Sponsored

 

[ReverendQ]

What issues, specifically, are you seeing? What settings are you inquiring about?

 

[hcrouch0092]

What issues, specifically, are you seeing? What settings are you inquiring about?

I took my truck in for no cruise and they replaced the front camera and bumper radar. Truck worked fine afterwards. But now I’m getting my “front camera fault” and “pre collision assist not available” again. And my 360 cams just all the sudden stopped working.

when going into for scan and looking into my ipma module configuration is showing all kinds of stuff to be disabled. For example, all cruise options, all lane keeping options, and blind spot options disabled as well. Was wondering maybe if the module is fried or maybe I messed with something I shouldn’t have and threw it off.

my truck is an xlt 302a. 360 cams, adaptive cruise, lane centering, etc. I’m not under warranty so I’m hoping it’s not the 1500 dollar ipma module but might be

 

[ReverendQ]

I took my truck in for no cruise and they replaced the front camera and bumper radar. Truck worked fine afterwards. But now I’m getting my “front camera fault” and “pre collision assist not available” again. And my 360 cams just all the sudden stopped working.

when going into for scan and looking into my ipma module configuration is showing all kinds of stuff to be disabled. For example, all cruise options, all lane keeping options, and blind spot options disabled as well. Was wondering maybe if the module is fried or maybe I messed with something I shouldn’t have and threw it off.

my truck is an xlt 302a. 360 cams, adaptive cruise, lane centering, etc. I’m not under warranty so I’m hoping it’s not the 1500 dollar ipma module but might be

I had a very similar experience trying to swap in an MY21 IPMA in place of my MY23 IPMA. I could never get the Front Camera Calibration to complete successfully and therefore I got the same messages in the IPC and had similar issues. I gave up on the MY21 IPMA.

If you want to see my working MY23 IPMA settings I can send you my MY23 IPMA AsBuilt for you to use with AsBuiltExplorer and compare against the spreadsheet for what should be set. You will have to compare using AsBuiltExplorer software, possibly with Excel and/or AI but using Easy Mode will not be adequate. PM me with your email if you want my IPMA AsBuilt.

Also is it possible dealer may have loaded the newest IPMA software supporting features we don't have on a 302a that may be one issue. But even if they didn't then they must recalibrate the camera if they swapped out a camera, IPMA, or associated cables.

@Spiffy you have any further advice?

Sponsored