Search results

Must have been a setup glitch. Worked fine this morning, no changes.

On my 2.7l 2021 STX I have swapped the gauge cluster to the 8” unit. I turned on the boost gauge, but it stays at zero. Anyone have any insight?

Does anyone know what the green two pin connection is for on the back of the 8” gauge cluster?

I did this upgrade on my 2021 STX. It works as expected, except the screen turns off with the key. My 8” screen stayed on until the door opened or the accessories timed out. Does anyone know the specific power sequence that the screen is expecting? Is one 12V+ line for the backlight?

I had this same message pop up. I took the truck to a dealer as it is still under warranty. They found that a wiring harness was chaffed under the alternator. They said that they cleaned and re-wrapped the harness. No more issue. -2021 2.7L

2021 STX. 2.7L, 3.55 rear. Sometimes when my truck is cold and I leave my driveway it will shift to 3rd momentarily, then when I lightly decelerate it will slip like neutral then slam into 1st when coming to a complete stop. After about 200 meters of odd accelleration everything will seem...

I have a 2021 XL 2.7EB. I am looking for suggestions for monitoring the intake air temp. Does anyone know if I can get it to display in the truck? If not, any aftermarket gauges that work well? I have an OBD plug in that works with my phone, but it is interrupted by the Sync 4. I know I could...

As far as I have been able to determine, you'll need to take it to the dealer for the keypad to be programmed. My dealer wanted $ 100 for the programming.

I have an XL with the 8" screen and the 360 camera. Works perfectly on the 8" display.

I went to my dealer today to have the trailer brake controller recall corrected. That operation took about an hour. I also asked them to program a stick on remote keypad. The dealer told me that they were unable to program it because the Ford web service was not working. How is that possible...

I get that, thank you. My problem is that it is not a fob. I need to get the truck to accept a keypad.

I have purchased the stick on keypad for keyless entry. I can’t seem to make the truck enter programming mode. I have followed the procedures of switching off/on 8 times, but it never cycles the locks. Any tips? I have a 2021 XL.

I was told that I cannot order the PowerBoost with an extended cab configuration, only regular and crew cab. Is this true? Why?????