Search results

You can hear it, which is the entire point, but it doesn't drone at all. Off the gas it is quiet, not a sound. The wife really didn't pay much attention to it so it must not have been too bad with the windows up. Sounds like a truck should IMO. Don't have to turn up the radio anymore to coverup...

Just installed a Corsa Sport on my '24 STX. Was looking for the same thing you are, no visible pipes. Nothing in the aftermarket that is off the shelf so I built my own tips and modified the system to be up and out of the way. Really liking the sound, even with the cylinder deactivation.

If your truck is really low I have heard of people having the driveshaft hit one of the cross members on the bottom of the bed. If the squeak is only happening when leaving the line look around and see if there are marks on the drive shaft or bed. I may be wrong but couldn't hurt to check.

Flash69, I installed the 12290115 kit (plus the rear anti-roll bar) specifically for the 4x4 installation (spring rate on the front coil-over is the only difference per Ridetech between the 4x2 and 4x4 kit by the way) It has the new upper control arms included in the kit, with very nice bushings...

I also wanted a non modified truck, but wasn't going to ruin a set of front tires every 5000 miles to do it. Just very thankful I am able to do all this work myself, couldn't imagine having to take it somewhere and have it done, then redone. Thant would be bad. I also spent quite a bit of cash...

I'm curious, is your's a 4x4 or a 4x2? I have a super cab 4x4 and had the same issue, ended up slotting the lower control arm holes 1/2" more to get it to align. Seems the '24 model has a different frame configuration than the previous year since the other components are the same part #"s. After...

I have a super cab 4x4 and used the second from the lowest hole in the rear shackle, wanted a little rake. I have no clearance issues. The front was another story. Could not get the truck to align due to too much camber as the LCA bolts were slammed all the way inboard. I ended up slotting the...