Search results

I know this. It keeps the water out of places that freeze.

WD40 in your window tracks, and door latch, will be your bestie at the coffee shop. A little bit goes a long ways! Enjoy that coffee!

You could take if off the console, and sand that area. Higher grit will leave a better finish...like 400. Then find a chrome vinyl, to wrap it with. It should come close to matching with a clean cut line. https://www.amazon.com/TECKWRAP-Chrome-Silver-Adhesive-1ftx5ft/dp/B07CZCZ4MB

Depending on how high the coilovers are adjusted, you may reach the travel limits of the CV joints and just rip them out if you bot them out. Saw this more than once in the Toyota Tacoma forum. Not a pretty picture.

Yup going to be a grandpa also in March! Can't wait! And nice job on getting the tailgate to work properly. I don't think I need this mod ...yet...

I would.just go with the 22's. They will clear the spindle and fill out the wheel wells better than 20's do.

Check the interior for sale forum here, and I would also look through eBay. You should be able to find one.

I would say that they are worried about the offset of your wheels being too positive. Being that the inside of the rim would rub the spindle somewhere. So I would start fishing around for the max amount of positive offset for 20" wheels that fit. That may be hard to find here as most have just...

I might try this first before a clay bar. https://www.chemicalguys.com/products/clean-slate-wax-stripping-wash Use this with a one time use only wash mit. It will be loaded with this crap when finished washing. Then follow with the clay to get the bigger spots that don't dissolve. This will...

Why stop at the transmission? Find a totaled GT500 with everything. Make sure it runs and drives. Then take out all of the F150 motor, trans, harness, ETC.... Replace with the motor, trans, harness, ETC...from the GT500. It will take a while. But it could be done.

Depending on the paint and clear they use, it may last longer than the stock paint.

Any interior cleaner from chemical guys is good to go! Been using them for everything for more than a few years now.

Tell them put their senors on 6" spacers and get to work....it can't be that hard!

And if this work gets done. You better put in a new trans cooler, and clean out the lines to and fo really well. You may have to replace those also.

I have a seal skin cover for my other car. It sits a lot and the cover works well. Top of the line model has a really soft covering inside. Even so, I still place flannel sheets over the car before I put on the cover. But with you being in Florida. I might be looking at a vinyl carport, with...

Do you have a link for these?

Those are surface defects from the casting process. Only skin deep. When the aluminum runs through the mold, it cools on the outside faster because of the cool sand it is cast in. So it has surface cracks and some minor delaminations in places. Usually these are spotted and tested with a dye...

Well you said that the front diff has been rebuilt and the IWE's replaced. I am kinda leaning towards the pinion bearing in the front diff. The throttle on off causing the noise to come and go leads me to this. When you load up the pinion it loads up the bearing. And if they are still finding...

How about the ability to take a RCSB truck to KR trim level. Sure would be nice to have all of the cameras, lights, and extra options on these trucks from the factory, and not have to add them in parts and pieces at a time.

Well if you are using Android Auto, then the programming for the radio comes from your phone. The only way to have your regular radio presets shown on my 24 XL when using AA is to manually switch the radio off of AA music choices to the radio. Then you will have to have the regular radio as the...