Search results

JL 10TW3D4 Subwoofer, Grill is damaged, but functions.. Woofer is perfect. Installed in an MTI Acoustics Box for Behind the Rear Passenger Side seat in an F150. Wired to 2 Ohms, 12AWG OFC cable internally. $500 Shipped for the package. I will separate for a bit more per piece if you just want...

Question for those who have upgraded and disconnected the rears for fronts only active. Have you lost your proximity beeps when in reverse? I am using the zen a2b interface. Wonder if we can route that “beep” to the front channel? B and O Eight speaker

As Stated.

SOLD

SOLD

Removed from truck as it interferes with radio reception. You will need to source the small .25 inch long screw for the third screw. Or not, frankly it’s perfectly fine with the 2 factory screws. This is the model that has the camera hole. There is a replacement washer cover included if needed...

Pending

Pair of Morel Maximo 6 6.5 Coax. Used for about a month in the rear door of an F150. Decided to Ditch the rears. Includes, Speakers, Box, Ford Speaker Adapter, Ford Wire Adapter, Install Bay Silicone Boot. These are ready to be mounted right up to most Ford rear doors. I will also include 2...

Hello, trying here because the trucks are so similar. I have a lightning Lariet with the large screen. The screen is dead, so my heated seats and steering wheel are stuck ON. Which is becoming a pain. Truck can’t be seen by ford tilll end of march. I tried to pull 12v , but seats still come on...

Does anyone have any ideas to mitigate the window rubbing noise? I’ve tried to stuff some tubing up in the top channel where the windo seats, but no change. Next I will try some foam.

Ok, I figured out how to get the door panel to fit back on normally with the blanking panels, I assume this works for the MTI ones or the SGS ones. First you have to trim the factory sound deaden/felt on the back of the door panel. What I did was just trim the heavy black stuff and not the felt...

The wind noise doesn't bother me as much as the window rubbing.. I've tried to stuff some tubing in the channel to make the window seat tighter.. but it doesn't seem to help.

2022 Lightning Lariat here, I assume the door panels are the same on all of the 14th gen. When the drivers window is up, over bumps there is a very annoying rubbing sound. Like the window is rubbing against its weatherstrip. If you put outward pressure on the window the noise stops, also if you...

Yes, on my 8 speaker I just go to the rear on the fader a couple clicks.

Thanks, I think its easiest just to run from aftermarket amp up each side and drop a new line from the a piller to the kick, rather than try to tie in behind head unit, 2022 Lightning, I'd hate to mess with that screen situation.

Thanks for the help folks.

I was in the front door today installing component woofer. I noticed the plug only has two wires in it? Is the tweeter in the A pilller fed from inside the kick panel or something? If so does anyone know the wire color? 2022, b and o 8 speaker.

Has anyone else used the MTI fillers on the 14th gen? It’s really tight when you put the door panel back on. The clip under the door lock always seems to pop off. I have it on now, I will see how it goes.

Ah. Yes I should have checked their also for a description. Thanks

Hello, the indent on the 2021-22 door blanking panels. Is that for some kind of door panel clearance? That’s the only thing I can think of. It’s attached with lock nuts and machine screws.