Search results

Appreciate that!!

Would you mind checking to see if I have any pending updates? 1FTFW7L86RFB26005

Could someone check for any updates for this VIN for me, much appreciated! 1FTFW7L86RFB26005

I had this same message pop up and different options than yours were greyed out after updating some modules with FDRS. I did a battery disconnect for about 5 minutes then everything went back to working afterwards.

They are vibration dampeners. Look at some of the older ford trucks like the 2011 that had these on the rear calipers

Just an update I did a battery disconnect/reset and the mykey volume limit to level 14 is no longer there and I can control the speed compensated volume now. Just some kind of software glitch it appears.

Those that did this update could you check and see if you can still change your speed compensated volume (off, low, medium, high) and if your volume goes past level 14.

There's no option in the cluster either

It has to have it because when I turn my volume up, it stops at level 14 and a message pops up saying MYKEY active, which I never set any keys to be MYKEY's.

I have about 2,000 miles on my 2024 platinum and noticed that I can't turn my volume past 14 and also the speed compensated volume setting can't be changed either. Under vehicle setting there is no option for Mykey and I bought the truck new and have both keys. Has anyone seen this issue or can...

I'm waiting to hear back from Ford but has anyone come across this issue. I've been using FDRS for a while now with no problem.

Anyone else with a 2024 that the A/C is not cooling very well. I only have 2,000 miles on it so I do plan on getting it checked out. Was just seeing if it is a common issue. I did use FDRS and there are no codes or updates. Also a significantly less amount of air from the outer vents compared to...

Thank you for that information

Before I start my IPC update on my 24 platinum, how long does it usually take?

Now I had already done a 5 gig APIM update that only took like 30 minutes, then a new TCU update showed up. After doing the TCU update this new APIM update showed up which show that many hours. Does that mean it's likely way more than 5 gigs if the first APIM update only took about 30 minutes?

Is this APIM update really going to take multiple hours like it says. It jumps from like 3 hours to 6 hours and back and forth.

Ok i got the APIM updated to the latest version(from 24058 rev 1197 to 24127 rev 1270) and now another TCU update popped. Do i just keep on updating until no more show up?

After seeing SSM 52730 i ignored the fault code and updated the GWM again and now there is an update for the APIM

Also the TCU now shows up RED with code U211B

After doing the TCU a GWM update showed back up is this normal?